检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:章飞洋 何进[1] Zhang Feiyang;He Jin(School of Physics and Technology,Wuhan University,Wuhan 430072,China)
机构地区:[1]武汉大学物理科学与技术学院,武汉430072
出 处:《半导体技术》2023年第9期770-775,共6页Semiconductor Technology
基 金:国家自然科学基金资助项目(61774113)。
摘 要:为满足高速光通信系统的应用,基于标准40 nm CMOS工艺设计了一款25 Gbit/s判决反馈均衡器(DFE)电路,采用半速率结构以降低反馈路径的时序要求。主体电路由加法器、D触发器、多路复用器和缓冲器组成,为了满足25 Gbit/s高速信号的工作需求,采用电流模逻辑(CML)进行设计。经过版图设计和工艺角后仿验证,该DFE实现了在25 Gbit/s的速率下可靠工作,能提供10 dB的均衡增益,峰-峰差分输出电压摆幅约为950 mV,眼图的垂直和水平张开度均大于0.9 UI,输出抖动小于3 ps,在1.1 V的电源电压下功耗为12.5 mW,芯片版图的面积为0.633 mm×0.449 mm。To meet the application requirements of high-speed optical communication systems,a 25 Gbit/s decision feedback equalizer(DFE) circuit was designed based on standard 40 nm CMOS technology.The circuit adopted a half-rate structure to reduce the timing requirements of the feedback path.The main circuit was composed of adder,D flip-flop,multiplexer and buffer,and was designed using current mode logic(CML) to meet the requirements of 25 Gbit/s high-speed signals.After layout design and process corner post simulation verification,the DFE operates reliably at a rate of 25 Gbit/s,providing equalization gain of 10 dB,a peak-to-peak differential output voltage swing of approximately 950 mV,and an eye diagram vertical and horizontal opening both greater than 0.9 UI.The output jitter is less than 3 ps,and the power consumption is 12.5 mW at a supply voltage of 1.1 V.The layout area of the chip is 0.633 mm×0.449 mm.
关 键 词:光通信 判决反馈均衡器(DFE) 码间干扰 半速率 互补金属氧化物半导体(CMOS)
分 类 号:TN715[电子电信—电路与系统] TN432
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.23.60.252