硫黄湿法成型过程数值模拟与操作参数优化  

Numerical simulation and optimization of operating parameters of sulfur wet molding process

作　　者：孙继鹏 韩靖 唐杨超 闫汉博 张杰瑶 肖苹 吴峰[2] SUN Jipeng;HAN Jing;TANG Yangchao;YAN Bowen;ZHANG Jieyao;XIAO Ping;WU Feng(Luoyang Jianguang Special Equipment Company Limited,Luoyang 471003,Henan,China;School of Chemical Engineering,Northwest University,Xi'an 710069,Shaanxi,China)

机构地区：[1]洛阳涧光特种装备股份有限公司,河南洛阳471003 [2]西北大学化工学院,陕西西安710069

出　　处：《化工进展》2023年第S01期189-196,共8页Chemical Industry and Engineering Progress

基　　金：国家自然科学基金面上项目(22178286)。

摘　　要：目前对于液硫固化成型机理的认识并不是很完善,而且实验方法也很难观测到颗粒内部,冷却水流场分布等情况,为了解决这一问题,在实验研究的基础上采用计算流体力学(computational fluid dynamics,CFD)模拟方法对硫黄湿法造粒过程进行数值模拟,对冷却成型设备进行数理建模,对比分析了不同下落高度、冷却水温度以及冷却水进口流速下的硫黄颗粒粒径分布与形貌,通过调整以上参数,得到硫黄湿法造粒过程的最佳参数组合并深入分析了硫黄湿法冷却成型规律。在实验结果的基础上,进一步验证及完善了成型罐模型和模拟工艺参数。研究结果表明,随下落高度增大,细粉硫占比增多,但硫黄颗粒粘连情况减少,得到硫黄湿法造粒过程中最佳参数组合为下落高度为30mm、冷却水温度为55℃、冷却水进口流速为2.5m/s。At present,the understanding of the mechanism of liquid sulfur solidification molding is not very complete,and it is difficult to observe the internal particles and the distribution of cooling water flow field under experimental methods.To solve this problem,based on experimental research,computational fluid dynamics(CFD)simulation method was used to numerically simulate the wet granulation process of sulfur,and mathematical modeling was conducted on the cooling molding equipment.Different drop heights were compared and analyzed,the optimal parameter combination for sulfur wet granulation process was obtained by adjusting the particle size distribution and morphology of sulfur particles under the temperature of cooling water and the inlet flow rate of cooling water.The law of sulfur wet granulation was analyzed in depth.Based on the experimental results,the forming tank model and simulation process parameters were further validated and improved.The research results indicated that as the falling height increases,the proportion of fine sulfur powder increases,but the adhesion of sulfur particles decreases.The optimal parameter combination for sulfur wet granulation process was a falling height of 30mm,a cooling water temperature of 55℃,and a cooling water inlet flow rate of 2.5m/s.

关 键 词：硫黄湿法造粒 计算流体力学模拟 最优参数 

分 类 号：TQ125.11[化学工程—无机化工] TB24[一般工业技术—工程设计测绘]