基于阻力分析的矩形通道内弹状流向搅混流转变特性研究  

Study on Transition Criteria of Slug Flow to Churn Flow in Vertical Rectangular Channel Based on Characteristics of Interfacial Force

作　　者：何清澈 张卢腾 潘良明[1,2] 许汪涛 闫美月 孙皖 马在勇 He Qingche;Zhang Luteng;Pan Liangming;Xu Wangtao;Yan Meiyue;Sun Wan;Ma Zaiyong(Key Laboratory of Low-grade Energy Utilization Technologies and Systems,Ministry of Education,Chongqing University,Chongqing,400044,China;Department of Nuclear Engineering and Technology,Chongqing University,Chongqing,400044,China)

机构地区：[1]重庆大学低品位能源利用技术及系统教育部重点实验室,重庆400044 [2]重庆大学核工程与核技术系,重庆400044

出　　处：《核动力工程》2023年第6期127-133,共7页Nuclear Power Engineering

基　　金：国家自然科学基金联合基金(U21B2059)。

摘　　要：确定两相流流型是两相流动相间阻力和传热计算的先决条件,因此不同流型间的过渡准则对反应堆安全分析有十分重要的意义。本文选取了截面尺寸为4 mm×66 mm、6 mm×66 mm、8 mm×66 mm、10 mm×100 mm共4种规格矩形通道开展了空气-水垂直向上两相流动流型实验研究,采用阻抗式空泡仪和差压变送器对截面空泡份额和轴向压降进行测量。研究结果表明,在相同液相表观流速下,随空泡份额的增加,两相摩擦压降波动的振幅在弹状流向搅混流转变时达到最大;在空泡份额为0.6时,开始发生弹状流向搅混流转变。实验结果还显示,在流型转变点后相间阻力梯度随空泡份额而快速增加,在力学特性层面,可以采用相间阻力梯度作为弹状流向搅混流转变的判据。The transitional criteria between different flow regimes is of great significance to the safety analysis of nuclear reactor operation,because determining the flow regime of two-phase flow is a prerequisite for calculating the interfacial force and heat transfer of two-phase flow.In this study,four types of rectangular channels with cross-sectional size of 4×66 mm,6×66 mm,8×66 mm and 10×100 mm were employed to conduct the research on air-water upward flow in rectangular channels,and the void fraction and pressure drop were measured by impedance void meter and differential pressure gauge respectively.The results show that,at the constant superficial liquid velocity,the amplitude of frictional pressure drop reaches the maximum value at the transitional point of slug flow to churn flow,and when the void fraction is 0.6,the transition from slug flow to churn flow begins.The experimental results also show that the interfacial force gradient increases rapidly with the void fraction after the flow regime transition point,and the interfacial force gradient can be used as the criterion for the transition from slug flow to churn flow in terms of mechanical characteristics..

关 键 词：两相流 矩形通道 流型 空泡份额 相间阻力 

分 类 号：TL334[核科学技术—核技术及应用]