检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:樊家成 张柯 陈飞 丁腾飞 王世昊 李宇坤 FAN Jiacheng;ZHANG Ke;CHEN Fei;DING Tengfei;WANG Shihao;LI Yukun
机构地区:[1]河南省计量测试科学研究院
出 处:《计量与测试技术》2024年第1期80-82,共3页Metrology & Measurement Technique
摘 要:为了提高在非标准安装条件下外夹式超声流量计的测量精度,本文以DN100管道为研究对象,构建L形弯管、L形渐缩管及L形闸阀扰流管3种非标准安装条件,研究外夹式超声流量计在非标准安装条件下的测量误差。结果表明:为保证外夹式超声流量计的测量精度,对于管道中存在弯头或弯头+渐缩管,应控制流量计的前端直管段长度不小于5D;对于管道中存在弯头+闸阀,应控制流量计的前端直管段长度在10D左右。In order to improve the measuring accuracy of external clamped ultrasonic flowmeter under non-standard installation conditions,this paper takes DN100 pipeline as the research object,builds L-shaped bend pipe,L-shaped taper pipe and L-shaped gate valve spoiler under non-standard installation conditions,and studies the measuring error of external clamped ultrasonic flowmeter under non-standard installation conditions.The results show that:in order to ensure the measuring accuracy of the external clamped ultrasonic flowmeter,the length of the straight pipe section of the front end of the flowmeter should be controlled not less than 5D if there are elbow or elbow+taper pipe in the pipeline.For elbow+gate valve in the pipeline,the length of the front straight pipe section of the flow meter should be controlled at about 10D.
关 键 词:非标准安装 弯头 渐缩管 闸阀 超声流量计 测量误差
分 类 号:TH814.92[机械工程—仪器科学与技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249