检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:梁波[1,2] 秦灿 牛佳安 肖靖航 文森 LIANG Bo;QIN Can;NIU Jia'an;XIAO Jinghang;WEN Sen(College of Civil Engineering,Chongqing Jiaotong University,Chongqing 400074,China;State Key Laboratory of Mountain Bridge and Tunnel Engineering,Chongqing Jiaotong University,Chongqing 400074,China;China Merchants Chongqing Communications Research&Design Institute Co.,Ltd.,Chongqing,400067,China)
机构地区:[1]重庆交通大学土木工程学院,重庆400074 [2]重庆交通大学省部共建山区桥梁及隧道工程国家重点实验室,重庆400074 [3]招商局重庆交通科研设计院有限公司,重庆400067
出 处:《中国安全科学学报》2024年第1期77-84,共8页China Safety Science Journal
基 金:重庆交通大学研究生科研创新项目(2022B0004);重庆市人才团队项目(2019-9-95)。
摘 要:为探究直线公路隧道入口段驾驶者的视觉负荷,首先,通过实车试验采集5种视觉指标,采用Topsis改进因子分析法建立视觉负荷评价模型;然后,分析不同时间及位置下视觉负荷的变化特征,基于构建的视觉负荷曲线提出行车舒适评价标准,并运用已发表数据验证构建负荷模型的泛化能力;最后,通过敏感度分析探究视觉指标对视觉负荷的影响程度。结果表明:当驾驶者位于距洞口-13~55 m(12:00)、-10~49 m(15:00)时,视觉负荷超过临界值(0.906),驾驶者的行车舒适度和安全性极低;洞口驾驶者的视觉负荷值和接近度远大于洞内和洞外;18:00的视觉负荷和接近度远低于12:00和15:00。视觉指标的敏感度参数从大到小依次为注视时间、瞳孔面积、注视次数、扫视幅度、扫视速度。In order to investigate the visual load of drivers at the threshold zone of linear highway tunnels,five visual indicators of drivers were collected through the real vehicle test.A visual load evaluation model was developed by the Topsis improved factor analysis method,the visual load at different times and locations was analyzed,the evaluation criteria of driving comfort were proposed based on the constructed visual load curve,the generalization ability of the constructed load model was verified by using published data,and finally,the influence of visual indicators on visual load was investigated by sensitivity analysis.The results show that when the driver locates about -13 m to 55 m(12:00)and -10 m to 49 m(15:00)from the entrance,the visual load exceeds the boundary value(0.906),indicating the driver's driving comfort and safety is extremely low.The visual load and closeness of the drivers near the entrance are much greater than those inside and outside the entrance,and the visual load and closeness at 18:00 are much lower than those at 12:00 and 15:00.The sensitivity parameters of the visual indicators are fixation duration,pupil area,fixation time,saccade range,saccade speed in descending order.
关 键 词:Topsis改进因子分析 公路隧道入口段 视觉负荷 行车安全 视觉指标
分 类 号:X910[环境科学与工程—安全科学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.135.190.163