检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:向欣欣 张耀平[1,2,3] 雷大星 XIANG Xinxin;ZHANG Yaoping;LEI Daxing(School of Resources and Environmental Engineering,Jiangxi University of Science and Technology,Ganzhou 341000,Jiangxi,China;Jiangxi Provincial Key Laboratory of Mining Engineering,Ganzhou 341000,Jiangxi,China;Gannan University of Science and Technology,Ganzhou 341000,Jiangxi,China)
机构地区:[1]江西理工大学资源与环境工程学院,江西赣州341000 [2]江西省矿业工程重点实验室,江西赣州341000 [3]赣南科技学院,江西赣州341000
出 处:《有色金属科学与工程》2024年第1期87-96,共10页Nonferrous Metals Science and Engineering
基 金:江西省教育厅科学技术研究项目(GJJ218511)。
摘 要:为了解围岩在变形及二次应力下矿体开采效应的影响,本文选取-410 m中段采用现场试验与数值模拟相结合的方法对崩落法采矿进行矿体效应研究。结果表明:围岩应力发生震荡变化,在矿体上下盘围岩附近存在应力明显降低区域,下盘大于上盘,顶板最大主应力达0.44 MPa,局部呈现应力集中,且应力集中部位呈现类似水平零散分布的现象。同时开采边界呈现裂隙发育的状态。水平矿体有轻微下沉趋势,且在该中段的水平巷道边界和顶板裂隙附近易出现断层破碎带。竖直方向变形明显,且倾斜部位呈椭圆分布,最大下沉位移值达8.00 mm,最大上升方向变形值为3.03 mm,交界线附近易受到应力挤压现象。该研究对及时准确地掌握岩体变形规律和矿山安全信息使矿山安全有效合理地进行开采具有一定的指导意义。In order to understand the influence of the mining effect of the surrounding rock under deformation and secondary stress,this paper selected the-410 m section to study the ore body effect of caving mining by combining field test and numerical simulation.The results show that the surrounding rock stress changes in shock,there is a stress reduction area near the upper and lower wall surrounding rock of the orebody,the foote is larger than the hanging wall,the maximum principal stress of the roof reaches 0.44 MPa,and local stress concentration.In addition,the stress concentration parts showed similar horizontal scattered distribution phenomenon.At the same time,the mining boundary presents the state of crack development.The horizontal ore body has a slight subsidence trend,and the fault fracture zone is easy to appear near the boundary of the horizontal roadway and the roof crack in the middle section.The deformation in the vertical direction is obvious,and the inclined part is elliptical distribution.The maximum subsidence displacement is 8.00 mm,and the maximum upward deformation is 3.03 mm.The stress extrusion phenomenon is easy to occur near the intersection line.The study has certain guiding significance to grasp the deformation law of rock mass and mine safety information in time and accurately so as to carry out mining safely,effectively and reasonably.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.16.81.94