检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:靳东亮 王高峰 马喜强 于伟涛 狄正贤 魏世忠[1,6] Jin Dongliang;Wang Gaofeng;Ma Xiqiang;Yu Weitao;Di Zhengxian;Wei Shizhong(National Joint Engineering Research Center for Abrasion Control and Molding of Metal Materials,Henan University of Science and Technology,Luoyang Henan 471023,China;Longmen Laboratory,Luoyang Henan 471023,China;Luoyang Bearing Science and Technology Co.,Ltd.,Luoyang Henan 471039,China;National Key Laboratory of Intelligent Mining Heavy Equipment,CITIC Heavy Industry Co.,Ltd.,Luoyang Henan 471039,China;Luoyang Institute of Science and Technology,Luoyang Henan 471023,China;School of Materials and Chemical Engineering,Zhengzhou University of Light Industry,Zhengzhou Henan 450000,China)
机构地区:[1]河南科技大学金属材料磨损控制与成型技术国家地方联合工程研究中心,河南洛阳471023 [2]龙门实验室,河南洛阳471023 [3]洛阳轴研科技有限公司,河南洛阳471039 [4]中信重工机械股份有限公司智能矿山重型装备全国重点实验室,河南洛阳471039 [5]洛阳理工学院,河南洛阳471023 [6]郑州轻工业大学材料与化学工程学院,河南郑州450000
出 处:《金属热处理》2024年第2期172-178,共7页Heat Treatment of Metals
基 金:国家重点研发计划(2020YFB2006805)。
摘 要:通过降低合金元素的含量设计一种低成本低合金中碳钢,研究了不同热处理工艺下的力学性能。通过控制总应变幅,对中碳钢的低周疲劳行为进行了探究。结果表明,在302℃盐浴淬火保温2 h后试验钢具有相对较高的抗拉强度,为957 MPa。随着盐浴淬火温度升高至312℃,抗拉强度下降,U型缺口冲击性能增加;再继续升高盐浴温度,冲击性能下降。随着盐浴保温时间的增加,试验钢的硬度呈下降趋势。高应变幅(0.80%)条件下,312℃盐浴淬火试验钢的初始硬化率较低;而302℃盐浴淬火具有较高强度马氏体的试验钢具有更高的低周抗疲劳强度和疲劳寿命。A low⁃cost low alloy medium⁃carbon steel was produced,and its mechanical properties were investigated.The low⁃cycle fatigue behavior of the tested steel was investigated by controlling the total strain amplitude.The results show that the tested steel salt bath quenched at 302℃for 2 h has a relatively high tensile strength of 957 MPa.As the salt bath quenching temperature increases to 312℃,the tensile strength decreases,but the U⁃notched impact property increases,with the salt bath temperature further increasing,the impact property is reduced.The increase of salt bath holding time results in the decrease of hardness of the tested steel.Under high strain amplitude(0.80%),the initial hardening rate of the steel salt bath quenched at 312℃is lower,while the tested steel with higher strength martensite salt bath quenched at 302℃has higher low⁃cycle fatigue strength and fatigue life.
分 类 号:TG161[金属学及工艺—热处理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249