检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:陈乾原 陈胜[1] 陈志华 赵文龙 邹远璐 CHEN Qian-yuan;CHEN Sheng;CHEN Zhi-hua;ZHAO Wen-long;ZOU Yuan-lu(College of Water Conservancy and Hydropower Engineering,Hohai University,Nanjing 210098,China;Zhejiang Orient Engineering Co.,Ltd.,Zhejiang 310016,China)
机构地区:[1]河海大学水利水电学院,江苏南京210098 [2]浙江国贸集团东方机电工程股份有限公司,浙江杭州310016
出 处:《水电能源科学》2024年第3期166-170,37,共6页Water Resources and Power
基 金:国家自然科学基金项目(52179062)。
摘 要:含长连接管的调压室可通过在连接管内设置小于其管径的阻抗孔来增强调压室的阻抗特性。为研究长连接内阻抗孔的位置及直径两种因子对此类调压室阻抗特性的影响规律,以水头损失系数和流量系数为优化目标,以位置和直径为优化变量,基于正交优化设计方法和CFD数值模拟软件,计算分析了各组合方案下的调压室阻抗系数和三维流场的变化规律。结果表明,阻抗孔前后水流湍流强度增幅明显,距离连接管两端端部越近,对调压室大井和管道系统内流场影响程度越大;当阻抗孔位于连接管顶部与调压室大井连接处,可最大程度发挥阻抗孔的阻抗效果,以阻抗孔与连接管管径比0.8为例,水头损失系数增幅约30%;连接管直径增大有效降低调压室局部流场压强最值浮动范围;阻抗孔位于靠近连接管顶部且不在大井连接处时,水流流出调压室时连接管及下游隧洞总体湍流强度较小,流场更稳定。The impedance characteristics of a surge tank with a long connecting pipe can be enhanced by setting a throttled orifice smaller than its diameter in the connecting pipe.In order to study the influence law of the position and diameter of the throttled orifice in the long connection on the impedance characteristics of such a surge tank,the head loss coefficient and flow coefficient were taken as optimization objectives,and the position and diameter were taken as optimization variables.Based on the orthogonal optimization design method and CFD numerical simulation software,the variation law of the impedance coefficient of the surge tank and the three-dimensional flow field under each combination scheme was calculated and analyzed.The results show that the turbulence intensity increases obviously before and after the impedance hole,and the closer the distance between the two ends of the connecting pipe,the greater the influence on the flow field in the surge tank well and pipeline system is.When the impedance hole is located at the connection between the top of the connecting pipe and the big well of the surge tank,the impedance effect of the impedance hole can be maximized.Taking the 0.8 diameter ratio of the impedance hole to the connecting pipe as an example,the water head loss coefficient increases by about 30%.The maximum floating range of local flow field pressure in the surge tank can be effectively reduced by increasing the diameter of the connecting pipe.When the impedance hole is located near the top of the connecting pipe and not at the big well joint,the overall turbulence intensity of the connecting pipe and the downstream tunnel is smaller and the flow field is more stable when the water flows out of the surge tank.
关 键 词:长连接管 阻抗式调压室 阻抗孔口位置 正交优化设计 三维流场
分 类 号:TV732.5[水利工程—水利水电工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28