UOE焊管机组铣边机刀盘转速计算模型及铣削参数分析  

Analysis of Calculation Model and Milling Parameter of the Cutter Head Speed of UOE Welding Unit Edge Milling Machine

作　　者：黄杰[1] 徐根涛[1] HUANG Jie;XU Gentao(Baoshan Iron&Steel Co.,Ltd.,Shanghai 201900,China)

机构地区：[1]宝山钢铁股份有限公司,上海201900

出　　处：《焊管》2024年第3期53-57,共5页Welded Pipe and Tube

摘　　要：为了合理设置铣削参数、提高铣边机生产效率,推导了UOE大直径直缝埋弧焊管铣边机刀盘转速计算模型,并将模型计算结果与实际生产数据进行了对比验证。验证结果显示,计算得出的参数与生产时的实际参数基本一致。根据模型计算公式,利用Matlab计算软件分析了铣削厚度、铣削线速度对夹钳小车速度的影响,表明铣削厚度、铣削线速度与夹钳小车速度均为线性正相关。In order to set the milling parameters reasonably and improve the production of the edge miller,a calculation model of the cutter head speed of the UOE large diameter straight welded pipe milling machine is published,and the calculation results of the model are compared with the actual production data.The verification results show that the calculated parameters are basically consistent with the actual parameters during production.According to the model calculation formula,the influence of milling thickness and milling line speed on the speed of the clamp car was analyzed using Matlab calculation software.The analysis showed that there was a linear positive correlation between milling thickness,milling line speed,and the speed of the clamp car.

关 键 词：UOE焊管机组 铣边机 铣削线速度 铣削厚度 夹钳小车速度 

分 类 号：TG506.9[金属学及工艺—金属切削加工及机床]