检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:马辉[1,2] 刘一 赵艳丽 白恒宇 MA Hui;LIU Yi;ZHAO Yan-li;BAI Heng-yu(State Key Laboratory of Eco-Hydraulics in Northwest Arid Region,Xi’an University of Technology,Xi’an 710048,China;School of Civil Engineering and Architecture,Xi’an University of Technology,Xi’an 710048,China;Research and Design Institute of Water Conservancy and Hydropower,Xi’an University of Technology,Xi’an 710048,China)
机构地区:[1]西安理工大学省部共建西北旱区生态水利国家重点实验室,西安710048 [2]西安理工大学土木建筑工程学院,西安710048 [3]西安理工大学水利水电土木建筑研究设计院,西安710048
出 处:《计算力学学报》2024年第2期320-327,共8页Chinese Journal of Computational Mechanics
基 金:国家自然科学基金(51408485);陕西省自然科学基础研究计划(2022JM-258);工程材料与结构加固福建省高校重点实验室(三明学院)开放基金(B170001-16)资助项目.
摘 要:为建立圆钢管型钢再生混凝土组合柱的恢复力模型,对11根圆钢管型钢再生混凝土组合柱试件进行了低周反复荷载试验研究,考虑了再生骨料取代率、配钢率及钢管径厚比等不同设计参数的影响,分析了组合柱的地震破坏形态及滞回性能。基于组合柱的力学特征及曲线形状,提出了圆钢管型钢再生混凝土组合柱骨架曲线的三折线参数模型,采用理论推导与数据拟合的方法确定了组合柱骨架曲线的模型参数。在此基础上,给出了组合柱的滞回规则和卸载规律,构建了组合柱的恢复力模型,计算滞回曲线与试验滞回曲线吻合良好,表明该恢复力模型较好地反映了反复荷载下组合柱的受力特征点及滞回性能,可为此类组合柱的推广提供技术参考。To establish the restoring force model of circular steel tubular composite columns filled with steel reinforced recycled concrete,11 specimens of the composite columns were tested under low cyclic loading.Considering the influence of different design parameters such as recycled aggregate replacement rates,steel ratio and diameter thickness ratio of the steel tubes,the seismic failure modes and hysteretic behaviors of composite columns were analyzed.Based on the mechanical characteristics and curve shapes of composite columns,a three-fold-line parameter model of the skeleton curves of composite columns was proposed,and the model parameters of the skeleton curves model are determined by theoretical derivation and data fitting.On this basis,the hysteresis rules and unloading law of the composite columns are established,and the restoring force model of composite column is constructed.The calculated hysteretic curve is in good agreement with the measured hysteresis curve,which shows that the restoring force model better reflects the stress of the composite columns under repeated loading feature points and the hysteretic performance,and can provide technical reference for this kind of composite column promotion.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.33