模拟海洋大气环境下钛铝连接件的电偶腐蚀研究  

Galvanic Corrosion of Titanium and Aluminum Couplings in Simulated Marine Atmospheric Environment

作　　者：董凯辉 宋影伟[1,2,3] 蔡勇 韩恩厚[1,3,4,5] DONG Kaihui;SONG Yingwei;CAI Yong;HAN Enhou(Key Laboratory of Nuclear Materials and Safety Assessment,Institute of Metal Research,Chinese Academy of Sciences,Shenyang 110016,China;School of Materials Science and Engineering,University of Science and Technology of China,Hefei 230026,China;Southern Marine Science and Engineering Guangdong Laboratory(Zhuhai),Guangdong Zhuhai 519000,China;Institute of Corrosion Science and Technology,Guangzhou 510530,China;School of Materials Science and Engineering,South China University of Technology,Guangzhou 510641,China)

机构地区：[1]中国科学院金属研究所核用材料与安全评价重点实验室,沈阳110016 [2]中国科学技术大学材料科学与工程学院,合肥230026 [3]南方海洋科学与工程广东实验室(珠海),广东珠海519000 [4]广东腐蚀科学与技术创新研究院,广州510530 [5]华南理工大学材料科学与工程学院,广州510641

出　　处：《表面技术》2024年第9期11-21,I0005,共12页Surface Technology

基　　金：中国科学院金属研究所优秀研究生创新基金(1193002090);国家自然科学基金(52371082);南方海洋科学与工程广东实验室(珠海)创新团队项目(311021013)。

摘　　要：目的探究海洋大气环境下飞机结构用钛铝连接件的电偶腐蚀行为,分析结构件各位置的电偶腐蚀差异,完善钛、铝金属间的电偶腐蚀机理。方法通过动电位极化曲线、零电阻电流(ZRA)及中性盐雾试验等,比较浸泡和薄液膜2种测试条件对腐蚀过程的影响。利用有限元模拟(FEM)表征电偶作用在钛铝表面的影响范围,并预测各位置的腐蚀程度,最后通过腐蚀形貌和失重试验加以验证。结果在模拟海洋大气环境下钛及铝合金的阴极反应速率相较于浸泡条件下有所提高,耦合后两金属间的电偶电流密度由浸泡时的1.52μA/cm^(2)提升至11.00μA/cm^(2),腐蚀形态由局部点蚀凹坑转变为连续网格状腐蚀条纹。另外,钛与铝金属间的电偶电位(Eg=-700 mV,vs.SCE)与阳极铝合金的自腐蚀电位(Ecorr,Al=-680 mV,vs.SCE)接近,两者间较低的电位差使得电偶作用在铝表面的影响距离只有10~15 mm。结论钛铝连接件的电偶腐蚀主要集中在与钛直接接触的铝合金交界处,但不同边界位置的腐蚀深度也可能相差4倍以上,这主要与电偶作用影响范围内的阴/阳极面积比有关。Titanium alloys and aluminum alloys are two of the most widely used lightweight metallic structural materials in the aviation industry.The sum of the two can reach 60%-80%of the overall material of the aircraft.In view of the complex internal structure of the aircraft and the large number of parts,the contact between dissimilar metals is very common,among which titanium-aluminum couplings are the most prevalent.The purpose of this paper is to investigate the galvanic corrosion behavior of titanium and aluminum couplings for aircraft structures in the marine atmospheric environment,and to theoretically analyze the difference of galvanic corrosion at different positions of structural parts,so as to further enrich the galvanic corrosion mechanism between titanium and aluminum.In order to compare the effects of immersion and thin liquid film test conditions on the corrosion process,potentiodynamic polarization curves,zero resistance current test(ZRA)and neutral salt spray test were used.Finite element modeling(FEM)was used to characterize the influence range of galvanic action on the surface of titanium and aluminum,and also predict the local corrosion.Finally,the corrosion morphology and weight loss test were conducted to verify it.In the simulated marine atmospheric environment,the cathodic reduction reaction rate on the surface of titanium and aluminum alloy was higher than that in the immersion condition,and the galvanic current density between the two metals was increased from 1.52μA/cm^(2) to 11.00μA/cm^(2).In addition,when the area ratio of titanium to aluminum was 1∶1 under the ideal condition,the galvanic potential between titanium and aluminum(Eg=-0.70 V,vs.SCE)was close to the self-corrosion potential of aluminum alloy(Ecorr,Al=-0.68 V,vs.SCE),and away from the sel-corrosion potential of titanium alloy(Ecorr,Ti=-0.30 V,vs.SCE).However,combined with the effect of solution resistance under actual condition,the influence range of galvanic action on these two metals were different.As for the cathodic titan

关 键 词：钛合金 铝合金 电偶腐蚀 有限元模拟 大气腐蚀 薄液膜 

分 类 号：TG174[金属学及工艺—金属表面处理]