检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:冯宇 匡冠霖 岳东 Victor O.Belko Sergey A.Maksimenko 杨洲[4] FENG Yu;KUANG Guanin;YUE Dong;Victor O.Beko;Sergey A.Maksimenko;YANG Zhou(School of Electrical and Electronic Engineering,Harbin University of Science and Technology,Harbin 150080,China;School of High Voltage Engineering,Peter the Great Saint Petersburg Polytechnic University,Saint Petersburg 859111,Russia;Institute for Nuclear Problems,Belarusian State University,Minsk 220030,Belarus;Harbin Institute of Large Electric Machinery,Harbin 150040,China)
机构地区:[1]哈尔滨理工大学电气与电子工程学院,黑龙江哈尔滨150080 [2]圣彼得堡彼得大帝理工大学高电压工程学院,俄罗斯圣彼得堡859111 [3]白俄罗斯国立大学核问题研究所,白俄罗斯明斯克220030 [4]哈尔滨大电机研究所,黑龙江哈尔滨150040
出 处:《绝缘材料》2024年第5期10-19,共10页Insulating Materials
基 金:国家自然科学基金面上项目(52177017)。
摘 要:热固性环氧树脂因具有优异的导热性能与绝缘性能在电工装备领域得到广泛应用,由于其具有稳定的三维网络结构和不溶性,回收再利用存在挑战性。本文将不同质量分数的氮化硼(BN)加入到环氧(EP)/4-甲基六氢苯酐降解体系中,制备出高导热、高绝缘、可降解型BN/EP复合材料,并对BN/EP复合材料的导热性能、介电性能以及可降解性能进行研究。结果表明:以2,4,6-三(二甲氨基甲基)苯酚作为催化剂,在乙二醇作用下该BN/EP复合材料可在200℃下实现常压降解。BN质量分数为15%的BN/EP复合材料热导率为0.335 W/(m·K),比纯EP树脂提高了34%;交流电气强度为101.7 kV/mm,比纯EP树脂提高了13%。BN/EP复合材料可经酯交换降解得到EP降解产物(EDP),与EDP复合后,BN/EP复合材料的导热性能和电气强度基本保持不变。Thermosetting epoxy resin is widely used in electrical equipment field due to its excellent thermal conductivity and insulating properties.Due to the stable three-dimensional network structure and insolubility of the thermosetting epoxy resin,its recycling and reuse pose challenges.In this paper,we added different mass fractions of boron nitride(BN)into the epoxy(EP)/4-methylhexahydrophthalic anhydride degradation system to prepare high thermal conductivity,high insulating,and degradable BN/EP composites,and studied their thermal conductivity,dielectric properties,and degradability.The results show that taking 2,4,6-tris(dimethylaminomethyl)phenol as the catalyst,the EP/BN composites can achieve atmospheric pressure degradation at 200℃under the action of ethylene glycol.The thermal conductivity of BN/EP composite with 15%mass fraction of BN is 0.335 W/(m·K),which is 34%higher than that of pure EP resin;the AC electric strength is 101.7 kV/mm,which is 13%higher than that of pure EP resin.BN/EP composites can be degraded through transesterification to obtain EP degradation products(EDP).After the BN/EP composites are compounded with EDP,the thermal conductivity and electric strength of the BN/EP composites is basically unchanged.
关 键 词:环氧基复合材料 降解回收 热导率 介电性能 酯交换
分 类 号:TM215[一般工业技术—材料科学与工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.223.213.54