检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘海波 刘玉丽 石祥锋 LIU Haibo;LIU Yuli;SHI Xiangfeng(Architectural Engineering College,North China Institute of Science and Technology,Langfang,Hebei 065201;College of Science,North China Institute of Science and Technology,Langfang,Hebei 065201)
机构地区:[1]华北科技学院建筑工程学院,河北廊坊065201 [2]华北科技学院理学院,河北廊坊065201
出 处:《地质与勘探》2024年第3期572-580,共9页Geology and Exploration
基 金:国家自然科学基金项目(编号:51774022)资助。
摘 要:复杂边坡稳定性问题一直是岩土工程界重点研究的问题之一,提高复杂边坡安全系数的方法有很多,其中采用抗滑桩支护是常用手段之一。以安徽省某高速公路复杂边坡为研究对象,采用套孔应力解除法对该边坡岩土体进行了地应力测试,以测试结果作为有限元分析的边界条件,分别对该边坡加固前和采用抗滑桩加固后两种工况进行数值分析,得到有代表性的有限元分析结果;并对有限元的计算出位移结果和实测位移进行了对比。分析表明,未采用抗滑桩支护的边坡,会产生局部应力过分集中、整体变形和水平向位移较大、塑性区贯通等不利于边坡稳定的危险状况。采用了抗滑桩支护后,贯通的塑性区消失,边坡变形和位移减少,应力分布趋于均匀,安全系数大幅度提高。有限元计算出的位移结果和实测位移十分接近,匹合度较好,从而说明了有限元分析手段的可靠性。The stability of complex slopes has always been one of the key research issues in the field of geotechnical engineering.There are many methods to improve the safety factor of complex slopes,among which the use of anti-slip pile support is one of the commonly used methods.Taken a complex slope of a highway in Anhui Province as the research object,in-situ stress tests were conducted on the rock and soil mass of the slope using the borehole stress relief method.The test results were used as boundary conditions for finite element analysis.Numerical analysis was conducted on the two working conditions of the slope before reinforcement and after reinforcement with anti-slip piles,and representative finite element analysis results were obtained.And the displacement results calculated by the finite element method were compared with the measured displacement.Analysis shows that slopes without anti-slip pile support can lead to dangerous situations that are not conducive to slope stability,such as excessive concentration of local stress,large overall deformation and horizontal displacement,and the continuity of plastic zones.After the use of anti-slip pile support,the run-through of the plastic zone disappears,the deformation and displacement of the slope decrease,the stress distribution tends to be uniform,and the safety factor greatly improves.The displacement results calculated by the finite element method are very close to the measured displacement,with a good fit,indicative of the reliability of the finite element analysis method.
分 类 号:P642.2[天文地球—工程地质学] TU457[天文地球—地质矿产勘探]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.147.77.120