AGM隔板的装配压力对阀控式铅酸蓄电池性能的影响  

Influence of assembly pressure of AGM separator on the performance of VRLA lead-acid battery

作　　者：成梓铭[1] CHENG Ziming(Shenyang Battery Research Institute limited liability company,Shenyang Liaoning 110178,China)

机构地区：[1]沈阳蓄电池研究所有限责任公司,沈阳辽宁110178

出　　处：《蓄电池》2024年第3期142-146,共5页Chinese LABAT Man

摘　　要：研究了AGM隔板的注液量、注液种类、纤维直径、增强隔板以及初始压力等因素对装配压力的影响。实验证明,注液量为饱和吸液量的90%,装配压力控制在60 kPa左右,可以明显改善阀控式铅酸蓄电池的循环寿命。In this paper,the effects of injection amount,type of injection,fiber diameter,reinforced partition and initial pressure on the assembly pressure of AGM separator were studied.The experimental results show that the cycle life of valve-regulated lead-acid battery can be improved obviously when the injection volume is 90%of the saturated suction volume and the assembly pressure is controlled at about 60 kPa.

关 键 词：阀控式铅酸蓄电池 饱和吸酸量 AGM 隔板注液量 注液种类 纤维直径 初始压力 回弹性 装配压力 

分 类 号：TM912.1[电气工程—电力电子与电力传动]