高速卷板机涂布辊轴失效分析及优化设计  

Failure analysis and optimization design of coating rollers for high-speed coilers

作　　者：李会荣[1] 张浩辰 任昭 LI Huirong;ZHANG Haochen;REN Zhao(Shaanxi Institute of Technology,Xi'an 710300,Shaanxi,China)

机构地区：[1]陕西国防工业职业技术学院,陕西西安710300

出　　处：《模具技术》2024年第3期48-56,共9页Die and Mould Technology

基　　金：2023年陕西国防工业职业技术学院重点项目(编号:Gfy23-12、Gfy23-08);2023年陕西国防工业职业技术学院教学改革重点项目(编号:GFJGZ202303);陕西省教育厅科研计划项目(编号:22JK0273)。

摘　　要：为解决涂布辊轴在高速旋转时阶梯轴连接处断裂的问题,对涂布辊轴进行了可靠性分析,通过理论计算和有限元仿真分析可知,连接处轴截面直径为110 mm的最大切应力为304.3~417.4 MPa,属于危险载荷。并且该处在4 000 N压力作用下,应力集中处与最大切应力处相同,两者相互叠加使得涂布辊轴在此处发生断裂。基于上述结果进行了尺寸优化分析,并提出了一种渐变型涂布辊轴结构,分析结果表明,其所受应力均在使用要求范围内。In order to solve the problem of fracture at the stepped shaft connection when the coating roller is rotating at high speed,the reliability analysis of the coating roller is carried out.Through theoretical calculations and finite element simulation analysis,the maximum shear stress at the connection where the diameter of the shaft cross-section is llo mm is 304.3-417.4 MPa,which belongs to the hazardous load,and through the finite element simulation analysis,the stress concentration at the place where the maximum By finite element simulation analysis,under 4000 N pressure,the stress concentration at this place is the same as that at the maximum shear stress,and the two are superimposed on each other,which makes the coating roller fracture here.Therefore,based on the above results,a size optimization analysis was carried out,and a progressive deformation coating roller structure was proposed,and the analysis results show that the stresses are within the range of use requirements.

关 键 词：涂布辊轴 失效分析 优化设计 有限元仿真 

分 类 号：TP391.9[自动化与计算机技术—计算机应用技术]