双通道打印下颌骨支架的有限元分析  

Finite element analysis of two channel printing mandible scaffold

作　　者：武佳宇 高丽兰[1,2] 孟露露 谭沿松 李瑞欣 张春秋[1,2] WU Jiayu;GAO Lilan;MENG Lulu;TAN Yansong;LI Ruixin;ZHANG Chunqiu(Tianjin Key Laboratory for Advanced Mechatronic System Design and Intelligent Control,Tianjin University of Technology,Tianjin 300384,China;National Demonstration Center for Experimental Mechanical and Electrical Engineering Education,Tianjin University of Technology,Tianjin 300384,China;Tianjin Stomatological Hospital,Tianjin 300041,China)

机构地区：[1]天津理工大学天津市先进机电系统设计与智能控制重点实验室,天津300384 [2]天津理工大学机电工程国家级实验教学示范中心,天津300384 [3]天津市口腔医院,天津300041

出　　处：《天津理工大学学报》2024年第3期111-116,共6页Journal of Tianjin University of Technology

基　　金：天津市多元投入基金项目面上项目(21JCYBJC00940);国家自然科学基金(11972198,12072235,52105158)

摘　　要：许多动物实验均证实了对打印支架施加10%压缩应变刺激时更利于细胞的增殖。为了探究这一原因,采用有限元技术,对支架进行单轴压缩10%应变的仿真研究,得到了支架的整体支反力情况、支架各层应力分布以及支架各层位移分布。结果表明:当支架发生10%压缩应变时,支架各层受力范围在0.2~0.6 N,最大形变发生在支架第二层与第三层接触的线束上,此处线束发生了扭转变形。将有限元结果与支架力学实验结果做比较,发现仿真结果与实验结果吻合良好。Many animal experiments have confirmed that the printed scaffold is more conducive to cell proliferation when stimulated by 10%compressive strain.In order to explore this reason,the finite element technology was used to simulate the mechanical behaviors of scaffold under compression of 10%,such as the overall support reaction,stress distribution and displacement distribution of each layer.The results show that when 10%compression strain occurs,the stress range of each layer of scaffold is 0.2-0.6 N.The maximum deformation occurs at the wire harness between the second and third layer,where torsion deformation occurs.Comparing the finite element results with the experimental results,there are good agreements between them.

关 键 词：下颌骨支架 压缩载荷 有限元法 双通道打印 

分 类 号：R459.9[医药卫生—治疗学]