电气设备橡胶密封圈失效分析  

Failure Analysis of Rubber Sealing Rings in Electrical Equipments

作　　者：张杰 赵洲峰 周宇通 裘吕超 刘学广 张俊[2] 宋涛[2] ZHANG Jie;ZHAO Zhoufeng;ZHOU Yutong;QIU Lyuchao;LIU Xueguang;ZHANG Jun;SONG Tao(State Grid Zhejiang Electric Power Co.,Ltd Research Institute,Hangzhou 310014,China;Wuhan University,Wuhan 430072,China)

机构地区：[1]国网浙江省电力有限公司电力科学研究院,浙江杭州310014 [2]武汉大学动力与机械学院,湖北武汉430072

出　　处：《橡胶工业》2024年第8期604-609,共6页China Rubber Industry

基　　金：国网浙江省电力有限公司科技资助项目(B311DS210014);湖北省教育厅科研计划指导性项目(B2021409)。

摘　　要：对变压器和电气绝缘开关设备(GIS)橡胶密封圈失效进行分析。结果表明:故障变压器故障相橡胶密封圈侧面存在长度为1 mm的2条裂纹,且橡胶密封圈的邵尔A型硬度提高和回弹值减小,橡胶密封圈出现老化失效现象;故障GIS开裂橡胶密封圈的裂纹起始处的Zn元素质量分数高于断面台阶处,即橡胶密封材料的填料分散不均匀,导致橡胶密封圈的物理性能降低,橡胶密封圈出现开裂失效现象。The failures of the rubber sealing rings in the transformer and gas insulated switchgear(GIS)were analyzed.The results showed that,there were two cracks with 1 mm of length existed on the side of the fault phase rubber sealing ring in the fault transformer,at the same time Shore A type hardness of the rubber sealing ring increased and rebound value decreased,the rubber sealing ring appeared aging failure phenomenon.For the cracked rubber sealing ring in GIS,the mass fraction of Zn element in the crack initiation point was higher than that in the section step area,suggesting uneven dispersion of fillers in the rubber sealing material,which led to the reduction of the physical properties and the cracking failure phenomenon of the rubber sealing ring.

关 键 词：变压器 电气绝缘开关设备 橡胶密封圈 失效分析 

分 类 号：TQ336.2[化学工程—橡胶工业]