检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:贾毅 黄子秋 韦朝宽 柳其钱 JIA Yi;HUANG Ziqiu;WEI Chaokuan;LIU Qiqian(School of Architectural Engineering,Kunming University of Science and Technology,Kunming 650500,China;Yunnan Vocational College of Transportation,Anning 650300,China)
机构地区:[1]昆明理工大学建筑工程学院,云南昆明650500 [2]云南交通运输职业学院,云南安宁650300
出 处:《交通科学与工程》2024年第4期32-39,共8页Journal of Transport Science and Engineering
基 金:国家自然科学基金项目(52068037);云南省自然科学基金项目(140520210091);云南省博士后科研基金项目(109820210012)。
摘 要:为探明某高墩大跨连续刚构桥在正常运营状态及最不利受力状态下的动静态荷载特性,基于成桥荷载试验方法,开展不同车辆位置、车速等条件下大跨连续刚构桥动静荷载现场试验。试验主要包括正载及偏载两种情况,静荷载试验测试了这两种情况下的主梁应变与挠度,动荷载试验分别在20、30、40 km/h车速下,通过无障碍行车试验和刹车试验,测试了桥梁的冲击系数、自振频率及动应变。在采集处理完现场数据后,将其与有限元软件的理论计算结果进行对比分析。研究结果表明:该连续刚构桥在正载及偏载两个工况下,挠度和应变实测值均小于理论计算值,相对残余应变最大值为18.8%,相对残余挠度最大值为11.71%,均不超过20%;在动载试验中,主桥一、二、三阶竖向实测振动频率均大于理论计算值;该连续刚构桥承载能力满足要求。To investigate the dynamic and static load characteristics of a high-pier long-span continuous rigid frame bridge under normal operational conditions and the most unfavorable stress states,dynamic and static load field tests were conducted based on the bridge load test method.These tests considered various vehicle positions and speeds.The testing encompassed two primary scenarios:positive load and partial load.In the static load tests,the strain and deflection of the main beam under these two conditions were measured.Dynamic load tests assessed the bridge′s impact coefficient,natural frequency,and dynamic strain through barrier-free driving and braking tests at speeds of 20,30,and 40 km/h.Upon collecting and processing the field data,a comparative analysis was performed against theoretical calculations obtained from finite element software.The results indicate that the measured deflection and strain values of the continuous rigid frame bridge are lower than the theoretical values under both positive and partial load conditions.The maximum relative residual strain is found to be 18.8%,and the maximum relative residual deflection is 11.71%,both of which are below 20%.Furthermore,the measured vertical vibration frequencies of the first,second,and third mode of the main bridge exceed the theoretical values.Overall,the bearing capacity of the continuous rigid frame bridge meets the required standards.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49