X射线能谱法与分光光度法测定聚酯切片中二氧化钛含量的比较分析  

COMPARATIVE ANALYSIS OF X-RAY SPECTROSCOPY AND SPECTROPHOTOMETRY IN THE DETERMINATION OF TITANIUM DIOXIDE IN POLYESTER CHIPS

作　　者：白志英[1] Bai Zhiying(Test&Measure Department of SINOPEC Tianjin Branch,Tianjin 300271,China)

机构地区：[1]中国石化股份有限公司天津分公司化验计量部,天津300271

出　　处：《精细石油化工》2024年第5期47-49,共3页Speciality Petrochemicals

摘　　要：采用了UV 2450分光光度仪和EDX-8000 X射线能谱仪分别测定了聚酯切片中的二氧化钛含量,对比分析了2种分析方法的操作条件。结果表明,X射线荧光度法的线性相关性、准确度、精密度均优于分光光度法,分析时间也由70 min缩短到30 min,并且二氧化钛的加标回收率能达到98%~102%,相对标准偏差为0.49。The content of titanium dioxide in polyester chips was determined by UV 2450 spectrophotometer and EDX-8000 X-ray spectrometer,respectively,and the operating conditions of the two analytical methods were compared and analyzed.The results show that the linear correlation,accuracy and precision of X-ray fluorescence spectrophotometry are better than spectrophotometry,and the analysis time is shortened from 70 min to 30 min.The recovery rate of titanium dioxide can reach 98%-102%,and the relative standard deviation is 0.49.

关 键 词：X射线能谱法 分光光度法 二氧化钛含量 

分 类 号：O657.3[理学—分析化学]