检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:谢红卉 XIE Honghui(State Grid Zhejiang Xiaoshan District Power Supply Co.,Ltd.,Hangzhou,Zhejiang 311200,China)
机构地区:[1]国网浙江杭州市萧山区供电有限公司,浙江杭州311200
出 处:《自动化应用》2024年第17期182-184,共3页Automation Application
摘 要:受线损和设备运行状态的影响,线路的运行性能偏低,为此,提出35 kV及以上分线同期线损管理与采集运维消缺研究。构建35 kV及以上分线同期线损数据的影响因素序列曲线,并根据实际线损数据状态调整对应的状态因素参数,分别从电力线路、三相平衡、用电负荷状态角度入手,实现对采集运维的消缺处理。结果表明,设计方法下的线损电量下降了80 MW,对应的功率因数达到了0.95,且线损率仅为20%,电压不平衡度下降了3%。Due to the influence of line loss and equipment operation status,the operational performance of the line is low.Therefore,a study on the management,collection,operation and maintenance of synchronous line loss for 35 kV and above branch lines is proposed.Construct a sequence curve of influencing factors for synchronous line loss data of 35 kV and above branch lines,and adjust the corresponding state factor parameters based on the actual line loss data status.Starting from the perspectives of power lines,three-phase balance,and power load status,achieve defect elimination processing for data collection and operation.The results showed that the line loss power under the design method decreased by 80 MW,corresponding to a power factor of 0.95,and the line loss rate was only 20%,with a 3%reduction in voltage imbalance.
关 键 词:35 kV及以上分线 同期线损管理 数据状态 无功步长 三相平衡
分 类 号:TP183[自动化与计算机技术—控制理论与控制工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.91