检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:侯宾东 李爱荣 杨怡青[3] 郭远智 姬伟华 陈兵兵 尹帅 刘梦 赵凯丽[1,2] HOU Bin-dong;LI Ai-rong;YANG Yi-qing;GUO Yuan-zhi;JI Wei-hua;CHEN Bing-bing;YIN Shuai;LIU Meng;ZHAO Kai-li(School of Earth Science and Engineering,Xi'an Shiyou University,Xi'an 710065,China;Shaanxi Provincial Key Laboratory of Petroleum Accumulation Geology,Xi'an Shiyou University,Xi'an 710065,China;Research Institute of Petroleum Exploration and Development,PetroChina,Beijing 100083,China;No.6 Oil Production Plant,PetroChina Changqing Oilfield Company,Xi'an 710200,China;No.2 Gas Production Plant,Changqing Oilfield Company,PetroChina,Xi'an 710200,China;Shaanxi Yanchang Petroleum(Group)Co.,Ltd.,Yanchang Gas Field Production Plant 3,Yan'an 716000,China)
机构地区:[1]西安石油大学地球科学与工程学院,西安710065 [2]西安石油大学陕西省油气成藏地质学重点实验室,西安710065 [3]中国石油勘探开发研究院,北京100083 [4]中国石油长庆油田分公司第六采油厂,西安710200 [5]中国石油长庆油田分公司第二采气厂,西安710200 [6]陕西延长石油(集团)有限责任公司延长气田采气三厂,延安716000
出 处:《科学技术与工程》2024年第25期10635-10644,共10页Science Technology and Engineering
基 金:国家自然科学基金(41772140);国家科技重大专项(2011ZX05044);中石化科技攻关项目(P14150)。
摘 要:致密油藏油水关系复杂,地层水化学组分及其分布规律对指导致密油勘探具有重要意义。基于此,对双河地区长6油层组地层水化学组成、矿化度、水化学特征参数与沉积微相、有效厚度及产能之间的关系进行了深入研究。研究表明,双河地区地层水类型主要为CaCl_(2)型,地层水的矿化度主要分布在2201.2~153670.9 mg/L,平均为53947.2 mg/L。矿化度在50000 mg/L之前,含油饱和度随着矿化度的增加而降低的,而在50000 mg/L之后,含油饱和度随着地层水矿化度的增加而增加。这是由于,较高的矿化度代表好的保存条件,利于油气长期大规模聚集,因而含油饱和度较高;而当目的层矿化度处于10000~20000 mg/L相对低的范围时,主要对应3~5 m薄层单砂体组成的复合砂体,因而含油饱和度也相对较高。分析认为,目的层矿化度、钠氯系数、镁钙系数特征均表明目的层处于相对封闭的沉积环境,有利于油气的保存,这些水化学参数均与致密油藏聚集及产能有较为显著的相关性。The relationship between oil and water in tight reservoirs is complicated,so the chemical composition and distribution of formation water are of great significance to guide tight oil exploration.Based on this,the relationship between formation water chemical composition,salinity,water chemical characteristic parameters,sedimentary microfacies,effective thickness and productivity of Chang 6 oil formation in Shuanghe area was deeply studied.The research shows that the type of formation water in Shuanghe area is mainly CaCl_(2) type,and the salinity of formation water is mainly distributed in 2201.2~153670.9 mg/L,with an average of 53947.2 mg/L.The oil saturation decreases with the increase of the salinity before the salinity value of 5000 mg/L,while the oil saturation increases with the increase of the formation water salinity after the salinity value of 50000 mg/L.This is because higher salinity represents good preservation conditions,conducive to long-term large-scale accumulation of oil and gas,so the oil saturation is high.However,when the salinity of the target layer is in the relatively low range of 10000~20000 mg/L,it mainly corresponds to the composite sand body composed of 3~5 m thin layer single sand body,so the oil saturation is relatively high.According to the analysis,the characteristics of salinity,sodium chloride coefficient and magnesium calcium coefficient of the target layer all indicate that the target layer is in a relatively closed sedimentary environment,which is conducive to the preservation of oil and gas.These hydrochemical parameters are significantly correlated with tight oil reservoir accumulation and productivity.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7