检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:林君 LIN Jun(Fujian Academy of Building Research Co.,Ltd,Fuzhou 350108;Fujian Provincial Key Laboratory of Green Building Technology,Fuzhou 350108)
机构地区:[1]福建省建筑科学研究院有限责任公司,福建福州350108 [2]福建省绿色建筑技术重点实验室,福建福州350108
出 处:《福建建筑》2024年第8期18-21,共4页Fujian Architecture & Construction
基 金:福建省社会发展引导性(重点)项目(2022Y0047)。
摘 要:在风荷载作用下,柔性光伏支架易产生较大的变形和振动,应特点关注风振响应。因此,在SAP2000中,对三跨大跨度柔性光伏支架进行有限元建模,采用Davenport风速功率谱生成的风荷载时程作为荷载输入,分析柔性光伏支架在风荷载时程作用下的结构响应,并与静力风荷载作用下的结构响应进行对比。同时,考虑索与中部支架之间的摩擦作用,考察不同摩擦系数下结构的风振响应,探究摩擦力对柔性光伏支架风振响应的影响。结果表明,与静力分析相比,柔性光伏支架动力时程分析位移放大系数和索力放大系数分别为1.64和1.63;索与中部支架之间的摩擦作用能够增强结构整体耗能能力,有助于减小柔性光伏支架的风振响应;不同工况下的等效风振系数取值相差较大。因此在对柔性光伏支架进行静力分析时,应综合考虑实际情况,对风振系数进行合理取值。The flexible photovoltaic support structure may lead to significant displacement and vibration due to the wind load,so the wind-induced vibration response should be focused.The finite element model of three large span flexible photovoltaic support structure was modeled in SAP2000,and the wind load time history generated by the Davenport wind speed power spectrum was adopted as input load.The responses of the flexible photovoltaic support structure was obtained and compared with the responses under static wind load.Then,the friction between the cable and the middle bracket was considered,and the wind-induced vibration responses under different friction coefficients and the influence of friction on the wind-induced vibration responses of flexible photovoltaic brackets were investigated.The results indicated that the displacement and cable force amplification coefficient are 1.64 and 1.63,respectively,in dynamic time history analysis.The friction between the cable and the middle bracket can increase the energy dissipation capacity of the structure,which help to reduce the wind-induced vibration responses of the flexible photovoltaic bracket.The equivalent wind load amplification coefficient values varied greatly under different working conditions,so it is necessary to comprehensively consider the actual situation and choose a reasonable value for the wind load amplification coefficient when conducting static analysis of flexible photovoltaic support structure.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49