舰船用泵转子动力学特性研究  

Research on dynamic characteristics of marine pump rotor

作　　者：徐声海 郭超 赵虎坡 董亮[2] XU Shenghai;GUO Chao;ZHAO Hupo;DONG Liang(Navy Equipment Military Representative Office Based In Yangzhou,Yangzhou 225001 China;Research Center of Fluid Machinery Engineering and Technology,Jiangsu University,Zhenjiang 212013,China;Jiangsu Zhenhua Haike Equipment Technology Co.,Ltd.,Taizhou 225500,China)

机构地区：[1]海军装备部驻扬州地区军事代表室,江苏扬州225001 [2]江苏大学流体机械工程技术研究中心,江苏镇江212013 [3]江苏振华海科装备科技股份有限公司,江苏泰州225500

出　　处：《舰船科学技术》2024年第17期34-37,共4页Ship Science and Technology

基　　金：国家自然科学基金(52279087,51879122);泰州市重大科技成果转化项目(SCG202205)。

摘　　要：转子是船用泵中主要组件,其动力学特性对泵的性能和可靠性有非常重要的影响。本文以数值计算为基础对船用泵转子系统进行动力学特性分析。选取0.8Qd~1.2Qd等3种工况,分析船用泵转子系统强度和模态,得到其临界转速。结果表明,3种工况下转子应力和应变分布规律基本一致,最大应力、应变均分布在叶轮以及轴系中段位置;叶轮出口处的转子模态振幅最大;转子系统临界转速远大于额定转速,满足船用泵结构动力学及可靠性设计要求。The rotor is the main component in the marine pump,and its dynamic characteristics have a very important influence on the reliability of the pump.This paper analyzes the dynamic characteristics of marine pump rotor system based on numerical calculation.Three working conditions of 0.8Qd~1.2Qd were selected to analyze the strength and modal state of the rotor system of the marine pump and obtain its critical speed.The results show that:the stress and strain distribution of the rotor under the three working conditions are basically the same,and the maximum stress and strain are distributed in the impeller and the middle position of the shaft system;the amplitude of the rotor mode at the impeller outlet is the largest;the critical speed of the rotor system is much higher than the rated speed,which meets the requirements of the design of the marine pump structural dynamics and reliability.

关 键 词：船用泵 临界转速 模态 转子 

分 类 号：U664.58[交通运输工程—船舶及航道工程]