检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:黄秋茗 乐晨 朱海军 钟振涛 刘阳 李拥政 郭林峰 HUANG Qiuming;LE Chen;ZHU Haijun;ZHONG Zhentao;LIU Yang;LI Yongzheng;GUO Linfeng(School of Physics and Optoelectronic Engineering,Nanjing University of Information Science&Technology;Nanjing Metro Construction Co.,Ltd;China Railway(Shanghai)Investment Group Co.,Ltd;China Railway Tunnel Group No.2 Co.,Ltd;China Railway No.3 Group East China Construction Co.,Ltd;Jiangsu Key Laboratory for Optoelectronic Detection of Atmosphere and Ocean)
机构地区:[1]南京信息工程大学物理与光电工程学院 [2]南京地铁建设有限责任公司 [3]中铁(上海)投资集团有限公司 [4]中铁隧道集团二处有限公司 [5]中铁三局集团华东建设有限公司 [6]江苏省大气海洋光电探测重点实验室
出 处:《仪表技术与传感器》2024年第9期106-111,117,共7页Instrument Technique and Sensor
基 金:国家自然科学基金项目(62175113);江苏省重点研发计划项目(BE2022076)。
摘 要:针对基于短时傅里叶变换的布里渊光时域反射仪(STFT-BOTDR)系统噪声频谱泄漏导致的布里渊频移误差问题,提出利用布莱克曼窗函数解决频谱噪声的信号处理方法。首先搭建STFT-BOTDR系统,采集到包含系统变频模块产生低频噪声的布里渊信号,然后分别利用海明窗函数和布莱克曼窗函数解调的布里渊增益谱和布里渊频移分布。实验结果显示:利用布莱克曼窗函数比利用海明窗函数更能有效解决STFT-BOTDR系统中由于低频噪声发生频谱泄漏产生的谐波使布里渊增益谱失真的现象,减少布里渊频移的测量误差。实验表明利用窗函数解决系统频谱噪声的方法,在1.8 km的待测光纤上利用布莱克曼窗函数解调的布里渊频移分布测量精度达到1.4691 MHz,系统性能得到了提升,有利于加速低成本、中精度STFT-BOTDR系统的工程应用进程。A signal processing method using Blackman window function was proposed to solve the issue of Brillouin frequency shift error caused by noise spectrum leakage in the STFT-BOTDR system based on short-time Fourier transform.Firstly,the STFT-BOTDR system was built,and the Brillouin signal including the low-frequency noise generated by the system frequency conversion module was collected.Then the Brillouin gain spectrum and Brillouin frequency shift distribution demodulated by Hamming window function and Blackman window function were used respectively.The experimental results show that using Blackman window function is more effective than using Hamming window function to solve the phenomenon of Brillouin gain spectrum distortion caused by harmonics caused by spectrum leakage of low-frequency noise in STFT-BOTDR system,and the measurement error of Brillouin frequency shift was reduced.The experimental results show that the Brillouin frequency shift distribution measurement accuracy using Blackman window function demodulation on the 1.8 km optical fiber to be measured can reach 1.4691 MHz.The overall performance of the system was improved,which is conducive to the engineering application of low-cost and medium precision STFT-BOTDR system.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.118.126.145