检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵勇桃[1] 吴银虎 鲁海涛 王瑞 雷丙旺 Zhao Yongtao;Wu Yinhu;Lu Haitao;Wang Rui;Lei Bingwang(School of Materials Science and Engineering,Inner Mongolia University of Science and Technology,Baotou Inner Mongolia 014010,China;Inner Mongolia North Heavy Industry Group Co.,Ltd.,Baotou Inner Mongolia 014030,China)
机构地区:[1]内蒙古科技大学材料科学与工程学院,内蒙古包头014010 [2]内蒙古北方重工业集团有限公司,内蒙古包头014030
出 处:《金属热处理》2024年第9期47-50,共4页Heat Treatment of Metals
基 金:内蒙古科技大学重大横向课题(0904051709)。
摘 要:采用膨胀法,测定了P92钢的组织转变温度,并将其奥氏体化后实施不同温度和时间的等温处理。通过OM和SEM表征分析了不同等温温度、不同时间下P92钢的组织演变规律,并利用维氏硬度计测定其硬度。结果表明,P92钢在370℃及以下等温1 h时,会发生马氏体转变,室温组织为马氏体;在400~430℃等温1 h时,会发生贝氏体转变;在520~620℃等温1 h时,过冷奥氏体相对稳定,在短时间内不发生转变。在650℃及以上等温足够长时间时(25 h),过冷奥氏体将发生共析分解,形成类珠光体组织;在680~770℃等温25 h时,会有先共析铁素体析出,且随着等温温度的升高,先共析相增多。随着等温温度的升高(160~770℃),P92钢硬度整体呈下降趋势,由516 HV降低至163 HV。Microstructure transition temperatures of the P92 steel were determined by expansion method.After austenitizing,the steel was isothermal treated at different temperatures for different time.Microstructure evolution of the P92 steel isothermal treated at different temperatures for different time was analyzed by OM and SEM.Microhardness of the P92 steel under different states was measured by Vickers hardness tester.The results show that martensite transformation occurs at isothermal temperature of 370 C and below for 1 h,and microstructure of the P92 steel at room temperature is martensitic.Bainite transformation occurs at isothermal temperature of 400430 C for 1 h.When isothermal treated at 520-620 for 1 h,the supercooled austenite is relatively stable and doesn't change in a short time.When isothermal treated at 650 C and above for a long time(25 h),eutectoid decomposition of supercooled austenite occur,forming pearlitic structure.When isothermal treated at 680-770 C for 25 h,there is proeutectoid ferrite precipitation,and with the increase of temperature,the proeutectoid phase increases.With the increase of isothermal temperature(160-770℃),the hardness of the P92 steel shows an overall downward trend,and gradually decreases from 516 HV to 163 HV.
分 类 号:TG156.1[金属学及工艺—热处理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49