检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:常乐[1] 张万栋 刘翠芝[3] CHANG Le;ZHANG Wandong;LIU Cuizhi(School of Civil Engineering,Shenyang Institute of Urban Construction University,Shenyang 110167,China;China Water Resources Beifang Investigation,Design and Research Co.,Ltd.,Tianjin 300222,China;School of Resources&Civil Engineering,Northeastern University,Shenyang 110819,China)
机构地区:[1]沈阳城市建设学院土木工程学院,辽宁沈阳110167 [2]中水北方勘测设计研究有限责任公司,天津300222 [3]东北大学资源与土木工程学院,辽宁沈阳110819
出 处:《测绘与空间地理信息》2024年第10期71-74,82,共5页Geomatics & Spatial Information Technology
基 金:辽宁省教育厅基本科研项目——基于城市地理信息共享的CGCS2000坐标系转换研究(JYTMS20231545);沈阳城市建设学院科学研究发展基金项目(XKY202312)资助。
摘 要:针对高海拔低纬度地区,GNSS控制网存在投影变形的问题,如何选取合理的投影面和投影带建立坐标系,从而控制投影变形小于2.5 cm/km是问题的关键。文章从理论上分析长度变形的影响规律,提出合理的解决方法,通过工程案例验证该方法在实际工程中应用的可行性。Aiming at the problem of projection deformation in GNSS control network in high altitude and low latitude areas,choosing a reasonable projection plane and projection zone to establish a coordinate system,so as to control the projection deformation less than 2.5 cm/km is the key to the problem.This paper theoretically analyzes the influence law of length deformation,puts forward a reasonable solution,and verifies the feasibility of this method in practical engineering through engineering cases.
关 键 词:GNSS控制网 投影变形 中央子午线 抵偿高程面
分 类 号:P208[天文地球—地图制图学与地理信息工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49