新型热管堆装料及外推临界实验技术研究  

Research on Loading and Extrapolation Criticality Experiment Technology of New Heat Pipe Reactor

作　　者：张鹏展 杨历军[1] 肖启冬 刘凯凯 张振洋 ZHANG Pengzhan;YANG Lijun;XIAO Qidong;LIU Kaikai;ZHANG Zhenyang(Department of Reactor Engineering Technology,China Institute of Atomic Energy,Beijing 102413,China)

机构地区：[1]中国原子能科学研究院反应堆工程技术研究所,北京102413

出　　处：《原子能科学技术》2024年第10期2173-2179,共7页Atomic Energy Science and Technology

摘　　要：热管堆为当前先进核动力的研究热点。由于新型热管堆采用少量大块燃料,传统的外推临界实验技术适应性差,使其在装料及外推临界过程中面临安全挑战。本文结合该反应堆的特点,确定了先装配块状燃料,再逐步提升侧反射层达临界的方案。基于蒙特卡罗程序,计算分析了堆芯装配过程中的临界安全,确定了安全可控的初始堆芯装配方案;确定了中子源和探测器的布置;开展外推临界实验技术研究,针对直接外推侧反射层体积造成外推曲线上凸的问题,提出了以侧反射层的反应性价值为权重因子对体积进行加权处理的修正方法。利用此技术模拟了外推过程,结果表明本文确定的外推临界实验方案是可行的。本文结果可为新型热管堆装料及外推临界提供指导。With its passive characteristics,anti-single point failure characteristics,and simple system,the heat pipe reactor has become a hot research topic in advanced nuclear power.The loading criticality is an essential and important link before the heat pipe reactor is put into operation.Different from the traditional modular design of heat pipe fuel element,the new heat pipe reactor uses bulk fuel,and the traditional extrapolation fuel element/assembly and other extrapolation criticality experimental techniques have poor adaptability.Different from the KRUSTY reactor,the new heat pipe reactor has four side reflectors,and simultaneously lifting four side reflectors does not meet the regulations,which makes the new heat pipe reactor face safety challenges in the process of loading and extrapolation criticality.Therefore,combined with the characteristics of the reactor,the scheme of assembling bulk fuel was firstly determined,and gradually lifting the side reflectors to reach the criticality.Because of the large reactivity of bulk fuel,the core assembly process may face critical safety risks.To solve this problem,the critical safety in the core assembly process was calculated and analyzed by using Monte Carlo calculation program,and the safe and controllable scheme was determined.In the extrapolation process,the neutron fluence rate calculated by the detector is very important,and the size of the new heat pipe reactor is small,and the space available for the arrangement of the neutron source and the detector is limited.At the same time,the new heat pipe reactor is a fast reactor,and the neutron calculated by the detector is a thermal neutron.In order to solve the statistical influence of the neutron source and the detector on the neutron fluence rate in the extrapolation process,the Monte Carlo calculation program was used to determine the arrangement of the neutron source and the detector as well as the thickness of the detector cladding.In order to meet the principle of half addition,the new heat pipe reactor was propo

关 键 词：热管堆 块状燃料 侧反射层 装料 外推临界 

分 类 号：TL37[核科学技术—核技术及应用]