检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:孙中华 李建 王晓迪 刘欣[3] SUN Zhonghua;LI Jian;WANG Xiaodi;LIU Xin(College of Chemistry and Chemical Engineering,Taishan University,Taian,Shandong Province,271000;Shandong International Paper&Sun Coated Paperboard Co.,Ltd.,Yanzhou,Shandong Province,272100;College of Sciences,Northeastern University,Shenyang,Liaoning Province,110004)
机构地区:[1]泰山学院化学化工学院,山东泰安271000 [2]山东国际纸业太阳纸板有限公司,山东兖州272100 [3]东北大学理学院,辽宁沈阳110004
出 处:《中国造纸学报》2024年第3期20-30,共11页Transactions of China Pulp and Paper
基 金:国家自然科学基金(32271821);泰山学院引进人才科研启动基金项目(Y-01-2021023)。
摘 要:本研究以水溶性聚酰亚胺(PI)为增强剂,将纤维素纳米纤维(CNF)和芳纶纤维(PMIA/PPTA)悬浮液共混后,通过造纸法湿法成形制备CNF/PMIA/PPTA锂电池隔膜,并对隔膜性能进行了表征分析,探讨了各组分质量分数对隔膜机械性能及电化学性能的影响。研究结果表明,隔膜性能最佳的组分及用量(均相对于混合浆料总质量)为:CNF质量分数0.5%、PMIA/PPTA纤维质量分数0.5%(质量比5∶5)、硅藻土质量分数0.05%;PI水溶液喷涂量1.5%(相对于膜材料绝干质量)。此时,锂电池隔膜的拉伸强度为23.28 MPa,断裂伸长率为3.41%,吸液率、保液率和孔隙率分别为237.16%、152.88%和69.34%,热收缩率仅为0.31%,离子电导率可达1.041 mS/cm;由其组装的锂电池首次放电容量为158.2 mAh/g。CNF/PMIA/PPTA锂电池隔膜不仅具有优异的热稳定性和润湿性能,还具有较高离子电导率、较宽电化学稳定窗口、出色的倍率性能和循环性能,满足锂电池隔膜的技术安全要求。CNF/PMIA/PPTA lithium-ion battery separators were prepared by wet forming of paper-making method using water-soluble polyimide(PI)as reinforcing agent,and mixing cellulose nanofiber(CNF)and poly(ethylene oxide)-modified poly(aramid fiber)(PMIA/PPTA)suspension.After characterization and analysis of separator performance,the effects of dispersion and stability of CNF and PMIA/PPTA suspensions and the mass fraction of each component on the mechanical and electrochemical properties of the separator were investigated.The results showed that the composition and dosage for the optimum properties of separator was:CNF(mass fraction of 0.5%,relative to the mixed total pulp mass,the same below),PMIA/PPTA fibers(mass fraction of 0.5%,mass ratio of 5:5),diatomaceous earth(mass fraction of 0.05%);and PI aqueous solution was sprayed(spraying quantity of 1.5%,relative to the absolate dry mass of the separator).At this time,the tensile strength of the lithium-ion battery separator was 23.74 MPa,the elongation at break was 3.41%,the liquid absorption,liquid retention,and porosity were 237.16%,152.88%,and 69.34%,respectively,and the thermal shrinkage was only 0.31%,with an ionic conductivity of up to 1.041 mS/cm;the first discharge capacity of the lithium-ion battery assembled by separator was 158.2 mAh/g.The CNF/PMIA/PPTA lithium-ion battery separator not only had excellent thermal stability,but also higher ionic conductivity,wider electrochemical stabilization window,excellent multiplicity and cycling performance,which met the technical safety requirements of lithium-ion battery separator.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49