检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:朱硕 刘阅 祝叶 黄裕航 郑磊 栗文银 Zhu Shuo;Liu Yue;Zhu Ye;Huang Yuhang;Zheng Lei;Li Wenyin(Jianghan Machinery Research Institute Limited Company of CNPC;Coiled Tubing Operation Company of CCDC Downhole Service Company)
机构地区:[1]中石油江汉机械研究所有限公司,湖北省武汉市江汉区430024 [2]川庆钻探井下作业公司连续管作业公司
出 处:《石油机械》2024年第11期73-81,共9页China Petroleum Machinery
基 金:中国石油天然气集团有限公司科学研究与技术开发项目“200℃/105 MPa连续管钻磨射流作业工具研制”(2020b-4018);中国石油工程技术研究院有限公司产业基金项目“SmartCT系列连续管作业软件”(CPETCY202411);中石油江汉机械研究所有限公司研究课题“连续管技术力学及岩屑运移理论研究”(JJY202305)。
摘 要:目前连续管作业井筒气液两相流压力计算以单一模型为主,该模型难以有效模拟整个井筒的实际流动状况,亟需解决单一气液两相流动模型仅适用于一种流动工况,与实际井筒同时存在多种流动工况两者难以匹配的问题。为此,通过试验数据建立不同流动工况下的最优流动模型,在此基础上形成多模型组合优化的气液两相流计算方法。该方法能够针对不同的流动工况将整个井筒(管内/环空)合理划分为多个井段,每个井段采用对应流动工况下的最佳气液两相模型,最终完成整个井筒的压耗计算。通过将环空压力与泵压的相对误差分别与其他5种单一气液两相模型相比可知,优化模型综合平均相对误差最低为8.23%。该方法可为连续管作业施工方案的合理设计提供理论参考。A single model is usually used for calculating the gas-liquid two-phase flow pressure in wellbore with coiled tubing(CT)operation.However,this model is only applicable to one flow condition in the wellbore,but cannot effectively simulate the actual multiple flow conditions in the whole wellbore.In this paper,the optimal flow model for each flow condition was built using the test data,and accordingly an optimized gas-liquid two-phase flow combined model was formed.This combined model can divide the whole wellbore(in string/annulus)into multiple sections depending on flow conditions.The optimal gas-liquid two-phase model for corresponding flow condition is used for each section,and ultimately the pressure loss calculation is completed for the whole wellbore.The combined model was compared with each of the five optimal models in terms of relative error between annulus pressure and pump pressure.It is found that the average relative error of the combined models is 8.23%.This proposed combined model provides a theoretical reference for the rational design of CT operation plan.
关 键 词:连续管作业 井筒气液两相流 组合优化模型 流动工况 环空压力 泵压
分 类 号:TE319[石油与天然气工程—油气田开发工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.191.28.129