管材对涡流管能量分离效应的影响分析  

Analysis of the Influence of Pipe Materials on the Energy Separation Effect of Vortex Tubes

作　　者：黄志远 韩志宏 刘蜀阳 甘德俊 李申申 张健 李强 HUANG Zhiyuan;HAN Zhihong;LIU Shuyang;GAN Dejun;LI Shenshen;ZHANG Jian;LI Qiang(School of Mechanical and Electronic Engineering,Jingdezhen Ceramic University,Jingdezhen Jiangxi 333403,China;New Engineering Industry College,Putian University,Putian Fujian 351100,China)

机构地区：[1]景德镇陶瓷大学机械电子工程学院,江西景德镇333403 [2]莆田学院新工科产业学院,福建莆田351100

出　　处：《机床与液压》2024年第21期178-184,共7页Machine Tool & Hydraulics

基　　金：国家自然科学基金地区科学基金项目(52066006);景德镇市科技局项目(2019GYZD008-13);莆田学院引进人才科研启动项目(2024068)。

摘　　要：鉴于当前不同材料对涡流管内部流动特性的影响机制尚不清晰,采用CFD仿真研究5种涡流管管材(铜、铝、钢、PVC、木)对涡流管能量分离效应的影响。选用压缩空气作为工质,设置入口压力为0.1~0.5 MPa,冷流率为0.1,涡流管的L/D=16,采用Standardκ-ε模型对涡流管内的气体流动进行稳态数值模拟,获得不同材料、不同压力和不同粗糙度下的速度、压力及温度变化趋势。结果表明:金属材料的涡流管比非金属具有更高的温度梯度,且金属材料性能优于非金属材料,其性能由高到低依次为:铜、铝、钢、PVC、木;粗糙度升高,涡流管的制热性能增加,但制冷性能降低。In view of the unclear mechanism of the influence of different materials on the internal flow characteristics of vortex tube,the influence of five kinds of vortex tube(copper,aluminum,steel,PVC,wood)on the energy separation effect of vortex tube was studied by CFD simulation.Compressed air was used as the working fluid,the inlet pressure was set from 0.1 MPa to 0.5 MPa,the cold flow rate was set to be 0.1,and the L/D of the vortex tube was taken as 16,the steady-state numerical simulation of gas flow inside a vortex tube was carried out using the Standardκ-εmodel,and the variation trends of velocity,pressure,and temperature under different materials,pressures,and roughness were obtained.The results show that the metal vortex tube has a higher temperature gradient than the non-metal tube,and the metal material has better performance than the non-metal material,and its performance from high to low is:copper,aluminum,steel,PVC,wood;with the increase of roughness,the heating performance of vortex tube increases,but the cooling performance decreases.

关 键 词：涡流管 材料 能量分离 数值模拟 

分 类 号：TB61[一般工业技术—制冷工程] TB632