检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:杨战社[1] 张程[1] 荣相 YANG Zhanshe;ZHANG Cheng;RONG Xiang(College of Electrical and Control Engineering,Xi’an University of Science and Technology,Xi’an 710054,China;China Coal Technology and Engineering Group Changzhou Research Institute,Changzhou 213015,China;Tiandi(Changzhou)Automation Co.,Ltd.,Changzhou 213015,China)
机构地区:[1]西安科技大学电气与控制工程学院,陕西西安710054 [2]中煤科工集团常州研究院有限公司,江苏常州213015 [3]天地(常州)自动化股份有限公司,江苏常州213015
出 处:《煤矿安全》2025年第1期212-219,共8页Safety in Coal Mines
基 金:天地科技股份有限公司科技创新创业资金专项资助项目(2023-TD-ZD001-006,2023-TD-MS005)。
摘 要:矿井供电系统常采用中性点不接地方式或经消弧线圈接地方式,由于井下环境的特殊性和复杂性,其单相接地故障选线问题一直没有得到很好的解决。分析并比较了2种接地方式的优缺点和系统发生单相接地故障时的选线难点。介绍了矿井供电系统发生单相接地故障时的主动式选线法、被动式选线法(包括基于稳态信息选线法和基于暂态信息选线法)以及智能算法融合选线:主动式选线法主要通过检测注入信号判断故障线路;被动式选线法则基于故障发生后的稳态信息量和暂态信息量完成选线;智能算法融合选线能充分利用故障特征,发展前景广阔。针对目前故障选线方法未进行扰动识别、单一故障选线方法可靠性差、智能算法融合选线优势明显但未能得到很好应用等问题,提出了矿井供电系统故障选线方法的发展趋势。The mine power supply system usually adopts the neutral point ungrounded mode or the arc suppression coil grounded mode,due to the particularity and complexity of underground environment,the problem of single-phase grounding fault line selection has not been well solved.This paper analyzes and compares the advantages and disadvantages of the two grounding methods and the difficulty of line selection when single-phase grounding fault occurs in the system.This study introduces the active line selection method,passive line selection method(including the line selection method based on steady state information and the line selection method based on transient information)and the intelligent algorithm fusion line selection when the single phase grounding fault occurs in the mine power supply system.The active line selection method mainly detects the fault line by detecting the injected signal.The passive line selection rule is based on the steady state information and transient information after the fault occurs.Intelligent algorithm fusion line selection can make full use of fault characteristics and has a broad development prospect.In view of the problems such as no disturbance identification,poor reliability of single fault line selection method,obvious advantages of intelligent algorithm fusion line selection but not well applied,the development trend of fault line selection method of mine power supply system is proposed.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.16.50.172