锂电池烘箱结构设计及流体仿真分析  

Structure Design and Fluid Simulation Analysis of Lithium Battery Oven

作　　者：于杰 沈景凤[1] 仲梁维[1] Jie Yu;Jingfeng Shen;Liangwei Zhong(School of Mechanical Engineering,University of Shanghai for Science and Technology,Shanghai)

机构地区：[1]上海理工大学机械工程学院,上海

出　　处：《建模与仿真》2025年第3期212-221,共10页Modeling and Simulation

摘　　要：本文以锂电池加热烘箱为研究对象,使用SolidWorks对锂电池加热烘箱进行了三维建模和简化处理,在Flow Simulation模块中基于k−ε湍流方程完成了对烘箱进行了流体仿真,重点探讨了烘箱内部气流与温度分布对磷酸铁锂电池板加热效果的影响。在实验中,设定进风口温度为60℃,对磷酸铁锂电池板进行了20分钟的加热,其中0~800秒的风量为12 m3/s,800~1200秒的风量为8 m3/s。通过流体仿真,获得了锂电池板表面的温度分布图,以及烘箱内部的流线温度图、速度图和压力图。结果表明,在上述条件下,烘箱内锂电池经过20分钟加热后,最低温度为37.17℃,最高温度为52.33℃,满足产品设计要求,证明此烘箱结构设计合理,且这一研究为进一步优化锂电池加热烘箱的结构设计提供了重要的实验依据。Taking the lithium battery heating oven as the research object,this paper uses SolidWorks to con-duct three-dimensional modeling and simplified processing of the lithium battery heating oven,and completes fluid Simulation of the oven based on turbulence equation in the Flow Simulation module.The influence of air flow and temperature distribution in oven on the heating effect of lithium iron phosphate panel is discussed.In the experiment,the inlet temperature was set to 60˚C,and the lith-ium iron phosphate panelwas heated for 20 minutes,in which the air volume was 12 m3/s for 0~800 seconds and 8 m3/s for 800~1200 seconds.Through fluid simulation,the temperature distribution diagram of the surface of the lithium panel,and the flow line temperature diagram,velocity diagram and pressure diagram inside the oven are obtained.The results show that under the above condi-tions,afterheating the lithiumbatteryin theovenfor 20minutes,the lowest temperatureis37.17˚C,and the highest temperature is 52.33˚C,which meets the requirements of product design,proving that the structural design of the oven is reasonable,and this study provides an important experi-mental basis for further optimizing the structural design of the lithium battery heating oven.

关 键 词：锂电池 锂电池加热烘箱 流体仿真 FLOW SIMULATION 

分 类 号：TM912[电气工程—电力电子与电力传动]