检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:尚鹏举 王小鹏[1] Shang Pengju;Wang Xiaopeng(School of Electronic and Information Engineering,Lanzhou Jiaotong University,Lanzhou 730070,China)
机构地区:[1]兰州交通大学电子与信息工程学院,兰州730070
出 处:《电子测量与仪器学报》2025年第2期41-48,共8页Journal of Electronic Measurement and Instrumentation
基 金:兰州市科技发展计划项目(2023-3-104);甘肃省高校产业支撑计划项目(2023CYZC-40)资助。
摘 要:放射源密度检测系统是一种利用放射性同位素进行物质密度测量的仪器。在石油化工、矿业医疗都有应用,原理是放射源信号利用其本身优秀的穿透性,穿过装有物质的密闭管道,被闪烁体和光电倍增管检测到并转换为电压脉冲信号。而化工现场复杂环境会影响系统的工作性能,最明显直观的就是低温影响。相对于系统在标定温度下工作性能,系统在低温环境中输出脉冲计数率发生明显衰减,相对于标定温度20℃时单位时间系统采集脉冲计数,-30℃时最多时衰减能达到标定温度的25%,严重影响测量密度准确性,使系统输出变得不可靠,引发现场工作人员误操作。因此,对系统在低温下的输出进行补偿势在必行,通常根据系统中受温度影响期间来进行相应补偿,如高压模块在低温下输出不稳定,则进行高压补偿,对光电倍增管低温下倍增减少情况进行阈值补偿等,这些补偿方式有效但效果有限,引入基于概率主成分回归模型的温度补偿方法,在不对硬件做改动的情况下,依据收集到的脉冲衰减数据,构建PPCR模型,并进行补偿。测试结果表明,低温环境中该补偿方法能够将计数率损失能够控制在3%以下,提升了系统在低温环境下的密度检测精度。The radioactive source density detection system is an instrument that uses radioactive isotopes to measure material density.It has applications in petrochemical,mining,and medical industries.The principle is that the radiation source signal utilizes its excellent penetrability to pass through a sealed pipeline containing substances,be detected by scintillators and photomultiplier tubes,and converted into voltage pulse signals.However,the complex environment of chemical sites can affect the performance of the system,with the most obvious and intuitive being the impact of low temperatures.Compared to the performance of the system at calibration temperature,the output pulse count rate of the system significantly decreases in low-temperature environments,reaching up to 30%at most,resulting in a decrease in measurement density accuracy and even causing misoperation by on-site personnel,making the system output unreliable.This article introduces a temperature compensation method based on probabilistic principal component regression model,analyzes the changes of key detection devices such as scintillators and photomultiplier tubes in the system at low temperatures,collects attenuation data,and constructs a PPCR model without hardware modifications.The maximum expected estimation algorithm is used to estimate the attenuation parameter set of the model and compensate for it.The test results show that this compensation method can control the count rate loss below 3%in low-temperature environments,improving the density detection accuracy of the system in lowtemperature environments.
关 键 词:闪烁体 光电倍增管 温度衰减补偿 概率主成分回归(PPCR) 密度检测
分 类 号:TP212.9[自动化与计算机技术—检测技术与自动化装置] TN206[自动化与计算机技术—控制科学与工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.198