Ti-1100/0.1Y高温钛合金等温热压缩变形行为  

Hot Deformation Behaviours of Ti-1100/0.1Y Alloy Through Isothermal Hot Compression Tests

作　　者：崔文芳[1] 洪权[2] 刘春明[1] 周廉[2] 

机构地区：[1]东北大学材料与冶金学院,辽宁沈阳110004 [2]西北有色金属研究院,陕西西安710016

出　　处：《东北大学学报（自然科学版）》2003年第6期572-575,共4页Journal of Northeastern University(Natural Science)

基　　金：辽宁省自然科学基金博士启动基金资助项目(2001102019)

摘　　要：利用热模拟实验机对Ti 1100/0.1Y高温钛合金在温度990～1100℃,变形速率在0 001～10s-1范围内进行等温热压缩实验,观察变形后的显微组织,并根据动力学材料模型绘制出热加工图·结果表明:温度变化不改变σ ε曲线特征,但在 ε=10s-1时,出现流变不稳定性; ε=0.1～1s-1时,组织发生β相再结晶; ε=0 001～0 01s-1时,出现动态回复·综合考虑可热加工性和组织细化因素,温度在990～1020℃,变形速率在0 01～1s-1范围是良性热加工区域·Hot deformation behaviours of Ti-1100 alloy adding 01% (mass) ytrrium were st udied by thermalsimulator in the temperature range 990～1?100?℃ and strain ra te range 0001～10?s-1. The deformation map during hot working and good processing performance field are established. The microstructures were observed by optical microscope. The experimental results indicate that the variation of d eformation temperature doesn't change the characteristics of true stress- strai n curves but the variation of strain rate has crucial effect on the deformation map. The instable flow happens at strain rate 10?s-1,β phase dynamic recrystallization at 0.1～1?s-1 and dynamic recovery at 0001～001?s -1. Considering workability and microstructure refining, the optimum condi tions for Ti-1100/01Y alloy hot deformation are found out in the temperature range 990～1?020?℃ and strain rate range 001～1?s-1.

关 键 词：高温钛合金 热模拟 热加工参数 组织 热加工图 变形机制 

分 类 号：TG142[一般工业技术—材料科学与工程]