组合杆柱油井最大下泵深度的线性图解法  

Linear graphic method of the maximum pumping in depth of integral string well

作　　者：黄满良[1] 张广叶 李国韬[1] 张妍[1] 刘世强[1] 韩莉[1] 

机构地区：[1]大港油田集团钻采工艺研究院,天津300280 [2]中国石油大港石化公司,天津300280

出　　处：《石油矿场机械》2003年第3期14-18,共5页Oil Field Equipment

摘　　要：抽油井的最大下泵深度除与油井本身深度、油管强度、液面位置等有关外,还与抽油杆强度、抽油机所能承受的最大悬点载荷以及抽油机曲柄轴所能承受的最大扭矩有关,而理论推导表明,满足以上3个参数的关系式,都是组合抽油杆柱中各种抽油杆长度的线性关系式,据此,现文结合大港油田王27区块油井组实际,通过推导计算和讨论绘制出一张同时满足以上3个参数的线性关系曲线。利用此图可非常简便地进行杆柱强度校核和计算下泵深度。In addition to well depths, tubing strength and fluid level position, the maximum pumping in depth of pumping well also depends on the following three parameters:pumping rod strength, the maximum landing top load supported by pumping unit, and the maximum torque supported by crank shaft of pumping unit. But the theoretical inference indicates, the formula which meets the above three parameters is also linear formula of various pumping rod length among integral string. Hereby, based on factual status of a certain blocks' well group of Dagang Oilfield, this paper drafts a linear drawing which synchronously meets the above three parameters by inductive calculation and discussion. With the help of this drawing,the string strength can be checked conveniently and the depths of pumpingin can be calculated. 

关 键 词：抽油杆 抽油泵 深度 线性 图解 

分 类 号：TE933.02[石油与天然气工程—石油机械设备]