检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:何立明[1] 王华[1] 阎广建[1] 李小文[1] 朱文娇[1] 王锦地[1]
机构地区:[1]北京师范大学遥感与GIS研究中心,北京100875
出 处:《遥感学报》2003年第5期372-378,共7页NATIONAL REMOTE SENSING BULLETIN
基 金:国家重点基础研究发展规划项目 (编号 :2 0 0 0 0G7790 0 );国家自然科学基金项目 ( 4 0 10 10 2 0 );863项目 ( 2 0 0 1AA13 10 3 0 )共同资助
摘 要:气溶胶光学厚度作为描述气溶胶光学特性的重要参数之一 ,在辐射传输和大气订正中被广泛应用。与此同时 ,被广泛应用的大气辐射传输软件MODTRAN却采用水平气象视距作为其输入参数 ,两者之间在遥感应用中存在“脱节”。将两者联系起来对于气溶胶数据的合理利用是很有用的。本文的分析表明两者之间的关系随气溶胶垂直廓线的分布不同而异 ,为此 ,本文根据MODTRAN的模拟结果归纳出一个经验公式 ,分析表明 ,不同季节经验公式的系数是不同的 ,不考虑这种差异时 ,从相同的气象视距下转换得到的气溶胶光学厚度的误差最大可达 0 0 2 9。最后我们将经验公式用于大气订正中。Aerosol optical depth, one of the important parameters to describe the property of aerosol, is widely used in the region of Radiative Transfer and Atmospheric Correction; but at the same time, Meteorological Range but not Aerosol Optical Depth is used as an input parameter for the famous Radiative Transfer program: MODTRAN. It is reasonable to get the relative between Aerosol Optical Depth and Meteorological Range for the convenient using of all kinds of aerosol data. Though there are many expressions to describe the relative between them, the analysis in this paper shows that their relative change with the season change of aerosol profiles. An empirical expression was given here based on the simulation using MODTRAN4, and the coefficient of formula is different with the seasonal change of aerosol profiles. If this difference is ignored, the error of aerosol optical depth error may reach the level of 0.029 when the same meteorological range is transformed.
关 键 词:气溶胶光学厚度 气象视距 经验公式 MODTRAN 6S
分 类 号:X513[环境科学与工程—环境工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:13.59.144.10