检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:贾均红[1] 陈建敏[1] 周惠娣[1] 阎逢元[1] 周华[2]
机构地区:[1]中国科学院兰州化学物理研究所固体润滑国家重点实验室,甘肃兰州730000 [2]浙江大学流体传动及控制国家重点实验室,浙江杭州310027
出 处:《摩擦学学报》2004年第1期16-20,共5页Tribology
基 金:国家自然科学基金资助项目(59925513);浙江大学流体传动及控制国家重点实验室资助项目(9905);中国科学院国防创新基金资助项目(2001).
摘 要:对比考察了炭纤维增强聚四氟乙烯(PTFE)复合材料在干摩擦和水润滑条件下的摩擦磨损性能,并探讨了其磨损机理.结果表明:在水润滑条件下,纤维增强PTFE复合材料的摩擦系数和磨损率均明显比干摩擦下的低,水起到了润滑和冷却作用;复合材料磨损表面可见明显的裸露纤维及纤维局部磨平,无明显微观裂纹,基体和纤维结合较好,磨损表面存在转移自偶件的铁,表现出犁削磨损特征;在干摩擦下,复合材料磨损表面存在大量的微观断裂裂纹,纤维发生断裂和破碎,表现出疲劳磨损特征.Carbon fiber reinforced polytetrafluoroethylene (PTFE) composite was prepared by compression molding. The friction and wear behaviors of the resulting carbon fiber reinforced PTFE composite sliding against stainless steel at dry-and water-lubricated conditions were comparatively evaluated on an MM-200 test rig in a block-on-ring configuration. The morphologies of the worn surfaces of the PTFE composite and counterpart steel were observed on a scanning electron microscope, while the chemical state of F on the worn surface of the steel sliding against the PTFE composite at dry- and water-lubricated conditions was examined by means of X-ray photoelectron spectroscopy. It was found that the incorporation of the carbon fiber contributed to greatly increasing the wear resistance of PTFE, while the water as the lubricant further significantly increased the wear resistance of PTFE and its reinforced composite. This was attributed to the load-carrying capacity of the carbon fiber and the cooling and lubricating action of the water, which considerably decreased the friction-induced heat and hence hindered the plastic deformation and breakage of the PTFE matrix by the thermal effect. The PTFE composite was characterized by severe plastic deformation, adhesion, and fatigue, as it slid against the stainless steel at dry condition, while the plastic deformation and adhesion was greatly hindered under water lubrication.
关 键 词:聚四氟乙烯 炭纤维 复合材料 水润滑 摩擦学行为
分 类 号:TB333[一般工业技术—材料科学与工程] TH117.3[机械工程—机械设计及理论]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200