检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]西安邮电大学电子工程学院,陕西西安710121 [2]西安邮电大学通信与信息工程学院,陕西西安710121
出 处:《应用光学》2014年第2期353-358,共6页Journal of Applied Optics
基 金:西安市科技计划项目(CX12188)
摘 要:针对光纤通信中密集波分复用系统各信道的在线平坦光放大这一光通信问题,提出利用级联高非线性光纤来设计增益平坦的拉曼光纤放大器。对高非线性光纤(As-S光纤)拉曼增益谱前后沿进行线性拟合处理,利用不同波长泵浦抽运同种光纤,实现前放大后增益补偿,并考虑信号光损耗不同,在输出端得到了一个近似固定的功率输出值,并分析了影响拉曼光纤放大器输出特性的因素。模拟结果表明:平均增益为20.45dB,增益平坦度为0.15dB。In order to realize the flat inline amplification of all dense wavelength division multiplexing(DWDM)transmission channels in optical fiber communication systems,it was proposed to get gain-flattened Raman fiber amplifier based on cascading highly nonlinear fiber.An approximate value of output signal power at the output port was finally obtained considering different signal light losses,when the linear method was used for obtaining the Raman gain spectrum.Moreover,the average gain and gain flatness were 20.45dB and 0.15dB,respectively.Then,the factors for the output characteristics of Raman fiber amplifier were analyzed. Simulation results demonstrate that the designed Raman fiber amplifier has advantages of high gain,smaller gain flatness as well as simple configuration.
关 键 词:拉曼光纤放大器 级联光纤 增益平坦 高非线性光纤
分 类 号:TN929.11[电子电信—通信与信息系统] TN722[电子电信—信息与通信工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28