检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:吴玉萍[1] 赵之骏[1] 张建良[1] 侯惠奇[1]
出 处:《中国环境科学》2003年第6期653-653,共1页China Environmental Science
摘 要:研究了介质阻挡放电(DBD)常压下降解流动态苯乙烯时,不同电压、流速,初始浓度及湿度下苯乙烯的降解情况.结果表明,DBD降解苯乙烯15~20min即可达稳定,产物主要为CO、CO2和H2O;电压4800V时有少量带苯环的气态及固态物质产生,且随电压的升高而减少,到7500V时红外光谱已无法检测到;高电压下放电可以取得90%左右的降解率,产生带苯环的气态物质和结焦物质较少.流速在1.5cm/s,浓度为3000mg/m^3,相对湿度为20%左右时,降解效果最好.The degradation state of styrene under different voltage, velocity of flow, original concentration and humidity was studied mainly when the dynamic styrene was degraded under general pressure of dielectric barrier discharge (DBD). The results showed that the degradation of styrene by DBD could be stable within 15~20min, and the main products were CO2, CO and H2O. Little amounts of gas and solid matter with phenyl were produced under the voltage of 4800V and these amount decreased with increasing of the voltage. At the voltage of 7500V, no matter was found in FT-IR spectra. Under high voltage, the discharge state was better with the degradation rate up to about 90%; and the produced matter with phenyl and coked matter were less. The degradation efficiency was the best with velocity of flow at 1.5cm/s, concentration of 3000mg/m3 and relative humidity of 20%.
分 类 号:X783[环境科学与工程—环境工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.3