检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]大庆石油学院土木建筑工程学院,黑龙江大庆163318 [2]哈尔滨工业大学土木工程学院,黑龙江哈尔滨150090 [3]大庆石油管理局钻井二公司,黑龙江大庆163712 [4]大庆油田天宇工程设计有限责任公司,黑龙江大庆163453
出 处:《大庆石油学院学报》2004年第2期118-121,共4页Journal of Daqing Petroleum Institute
基 金:黑龙江省教育厅科技项目 ( 10 5 3 10 42 )
摘 要:利用数值分析方法 ,讨论了集中荷载作用下受拉钢筋暴露的钢筋混凝土简支梁的工作性能 ;分析了集中荷载位置、开口的宽度和高度、受拉钢筋的配筋率、混凝土强度、是否配架立筋以及开口的位置等因素对开口梁受弯性能的影响 ;指出了开口高度对开口梁残余承载力影响最大 ,当开口边缘位于梁弯矩最大位置时 ,梁残余承载力降低的幅度最大 ;并给出了施工建议 。According to the numerical analytical theory suggested in this paper, a discussion is carried out about the effect of various parameters (the loading position of concentrated load, width and height of exposed main reinforcement, percentage area of reinforcement in beam section, strength of concrete, if or no minimal top steel is used, distance of the end of exposed reinforcement from the left support) on the ultimate load bearing capacity of beams with exposed tensile reinforcement under concentrated load. And according to the analytical theory, some advice and outline have been brought forward. The effect of the biggest parameter on the remnant strength is the height of exposed main reinforcement, the next is the width and the loading position of concentrated load. When the loading position of concentrated load exerts an effect on the area of exposed tensile reinforcement, the depressed extent of remnant strength. is much bigger. When the loading position of concentrated load effect on the position of maximal moment, the depressed extent of remnant strength. is the biggest. Based on the result, we can realize the change of remnant strength of beam in the process of reinforcement. It is the support of reinforced construction.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.16.206.12