薄壁件液态模锻成形新工艺  

A New Technology on Liquid Forging of Thin Wall Pieces

作　　者：任学平[1] 初元璋[1] 

机构地区：[1]北京科技大学压力加工系

出　　处：《北京科技大学学报》1993年第3期281-286,共6页Journal of University of Science and Technology Beijing

摘　　要：本文对簿壁波导弯头件的液态模锻成形进行了研究。研究结果表明:液态模锻波导弯头件的尺寸精度在0.02mm～0.04mm之内,满足波导器件的标准化、积木化、组合化和稳定化的要求。采用该项新技术,可以提高材料的利用率和生产效率,降低成本。Liquid forging processing to thin wall waveguide angle head has been experimentally studied. The results show that the dimensional tolerance of waveguide angle head by liquid forging processing are 0.02- 0.04mm, it meets the requirements of standardization, building block system, built-up type and stability to waveguide parts. This new technology can increase high percentage of stock utilization and productivity efficiency, and lower cost.

关 键 词：液态模锻 薄壁件 波导弯头 

分 类 号：TG315.2[金属学及工艺—金属压力加工]