检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张学梅[1] 李东[1] 马青华[1] 付波 秦宝兰 郝静远
机构地区:[1]西安思源学院能源及化工大数据应用教学研究中心,陕西 西安 [2]西安思源学院再生水厂,陕西 西安 [3]西安交通大学化工技术学院,陕西 西安
出 处:《水污染及处理》2022年第3期119-128,共10页Water Pollution and Treatment
摘 要:定义“工业透水率VMD”为1000 m2单位膜面积在1天单位时间和1 kPa单位膜压差下的m3透水体积。直接采用西安思源学院再生水厂3520天A2/O-MBR系统每日运转的日产水量和膜压差大数据依序计算VMD。剔除五类异常点后得到71%~78%有效VMD。人为地将每25个有效VMD划分为一个组单元,计算组单元的VMD算术平均值。拟合组VMD算术平均值与组单元得直线型工业透水率衰减方程。因为表示VMD算术平均值与组单元比较发散,所以按“年”为划分界限对组单元进行第二次降维得“年单元”,并计算年单元的VMD算术平均值。拟合年VMD算术平均值与年单元得幂型工业透水率衰减方程。用前期的衰减方程预测后一年的工业透水率,用当期的衰减方程实测后一年的工业透水率。定义误差比为预测值与实测值的相对大小。计算年工业透水率衰减是直接、简单且方便。所得结果既可以预测膜寿命,又可以自我学习不断优化,还得出预测时段不应小于三年,最好选择四到五年为宜。Defining “industrial permeability VMD” as the m3 permeable volume of 1000 m2 membrane area at 1 day and 1 kPa cross-membrane pressure difference. The VMD is directly calculated by using the daily water yield and cross-membrane pressure difference of 3520 days of Xi’an Siyuan A2/O-MBR system. After excluding five anomalies, 71% to 78% of effective industrial permeability was obtained. Each 25 effective industrial permeability was artificially divided into a group unit by the membrane pool, calculating the VMD arithmetic average of the unit. A linear regressive equation can be got through the VMD arithmetic mean and the group unit. Because it indicates that the arithmetic mean value of VMD is more divergent from the group unit, the group unit is reduced into the annual unit. A power equation is fitted the annual VMD arithmetic mean and the annual unit. The industrial permeability in the following year is predicted by the previous attenuation equation, and the industrial permeability in the following year is measured by the current decay equation. The error ratio is defined as the relative size of the predicted and measured values. Calculating the annual industrial permeability attenuation is straightforward, simple, and convenient. The results can not only predict the membrane life, but also continuously optimize self-learning. It also shows that the prediction period should not be less than three years, so it is best to choose four to five years.
关 键 词:算术平均值 衰减方程 透水率 膜寿命 大数据 计算组 误差比 单位膜
分 类 号:X703[环境科学与工程—环境工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222