基于膏体流变学的浓密机底流泵选型关键参数研究  

Research on Key Parameters of Pump Selection for Thickener Underflow Based on Paste Rheology

作　　者：陈辉[1,2] 王洪江[1,2] 吴爱祥[1,2] 刘斯忠[1,2] 焦华喆[1,2] 李红[1,2] 

机构地区：[1]金属矿山高效开采与安全教育部重点实验室,北京100083 [2]北京科技大学土木与环境工程学院,北京100083

出　　处：《矿业研究与开发》2015年第5期91-94,共4页Mining Research and Development

基　　金：国家自然科学基金重点项目(50934002);国家自然科学基金项目(51074013);"十二五"国家科技支撑计划项目(2012BAB08B02)

摘　　要：以前对于高浓度料浆或者膏体料浆的泵送选型研究很少。以某铜矿膏体充填推荐配比为实验方案设计基础,通过配制不同浓度的料浆模拟不同浓度的深锥底流,利用流变仪分析重量浓度为67%~72%的料浆流变参数,为泵送选型提供理论依据。结合矿山设计充填能力确定出底流最大流量,然后通过底流输送管道的摩阻计算得出底流输送至搅拌槽的总扬程。经过计算,深锥底流泵必须满足扬程45m、流量85.64m3/h的设计要求,按这两个关键参数选取的泵既能满足生产需求又能节约成本。There were seldom pump selection researches on high-density slurry or paste slurry in the past.Taking the recommended ratio of paste backfill in a copper mine as experiment design basis,deep underflows with different concentrations were simulated through preparing different slurries.And the rheological parameters of slurry with weight concentration of 67% ~72% were analyzed by rheometer,which proved theoretical foundation for pump selection.Combining with the designed filling capacity of mine,the maximum underflow was determined,then total head of underflow transporting to stirred tank was calculated through frictional resistance of transmission pipeline.Through calculation,thickener underflow pump must meet the design requirement with lift of 45 m and flow of 85.64 m3/h.The pump,selected by the two key parameters,not only satisfied production requirements but also saved cost.

关 键 词：膏体充填 流变特性 底流泵 设备选型 

分 类 号：TD463[矿业工程—矿山机电]