烧结Fe_3Al金属间化合物基摩擦材料的摩擦磨损性能研究  

Friction and Wear Behavior of Sintered Fe_3Al Intermetallic-Based Friction Materials

作　　者：尹衍升 李静[1] 马洪涛[1] 

机构地区：[1]山东大学材料液态结构与遗传性教育部重点实验室,山东济南250061

出　　处：《摩擦学学报》2004年第5期457-461,共5页Tribology

基　　金：教育部博士点基金资助项目(20020422001);山东省重点基金资助项目(Z2002F02).

摘　　要：采用热压烧结方法制备了不同成分的Fe3Al金属间化合物基摩擦材料,考察了其物相、力学性能、抗氧化性及干摩擦磨损性能.结果表明,Fe3Al金属间化合物基摩擦材料密度低、强度高、抗氧化性好、摩擦系数稳定、高温耐磨性好;其在不同摩擦阶段的磨损机制存在差异,主要磨损机制包括磨粒磨损、塑性变形、裂纹萌生与扩展、微区脆性剥落及氧化磨损等.Fe3Al intermetallic-based friction materials with different compositions were prepared by hot pressing. The phases of the sintered samples were determined by means of X-ray diffraction, the hardness and mechanical strengths of the sintered samples were measured on a hardness meter and a universal material tester. Moreover, the friction and wear behaviors of the sintered samples with different compositions sliding against AISI-1045 steel in a block-on-ring configuration at ambient temperature were investigated on an MM-200 test rig, and the worn surface morphologies of the sintered friction materials were observed on a scanning electron microscope. Besides, the wear mass losses of the counterpart steel ring sliding against different sintered friction material samples were also determined on the same friction and wear tester. It was found that Fe3Al intermetallic-based friction material had low density, high strength, good oxidation resistance, smooth friction coefficient, and excellent wear resistance, and it led to a small wear of the counterpart steel ring as well. Thus the Fe3Al intermetallic-based friction material could be used as a friction material of good comprehensive properties. In addition, the sintered friction materials of different compositions were dominated by different wear mechanisms at different sliding stages. Namely, they were characterized by adhesion and abrasive wear at the early-stage sliding during which the wear rates increased slowly with increasing sliding distance. The sintered friction materials were dominated by plastic deformation, crack nucleation and propagation, and brittle spalling at the metaphase sliding during which the wear rates increased sharply with increasing sliding distance. At a large enough sliding distance, the sintered friction materials are characterized by oxidation wear and the rising rate of the wear rates with the sliding distance decreased to some extent, owing to the lubricity of the oxide layer.

关 键 词：FE3AL 金属间化合物 摩擦材料 摩擦磨损性能 粉末冶金 热压烧结 

分 类 号：TF125.9[冶金工程—粉末冶金]