环锭纺气圈环形成的双段气圈形态和张力分析  

A STUDY OF THE BALLOON CONTROL-RING FOR SPINNING

作　　者：金光成[1] 陈人哲[2] 张善同[2] 

机构地区：[1]中国纺织大学经纬纺织机械厂 [2]中国纺织大学机械系纺机教研室

出　　处：《中国纺织大学学报》1993年第5期73-80,共8页Journal of China Textile University

摘　　要：环锭细纱机安装气圈环后将形成上下两段气圈。本文采用修正波长后的正弦曲线近似解来代替椭圆积分精确解,两者所得结果非常接近;此外再考虑了空气阻力及气圈环对纱线滞后作用的影响,就此两段气圈形态和张力进行了分析计算,既能使计算得到简化,又能保持较高的计算精度。The balloon control-rings used in ring frames divide the spinning balloon into two parts:the upper one and the lower one.This paper uses the sine curve approximation with modifiedwave length corrections to analyze and calculate these two parts of controlled balloon,andwith the air drag acting on the balloon yarn also being considered.The results of calculationare very near those based on elliptic integral,but the calculation procedure is much simpler.

关 键 词：环锭精纺机 气圈环 气圈形态 

分 类 号：TS103.231[轻工技术与工程—纺织工程]