检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]西安科技大学通信与信息工程学院,陕西西安710054
出 处:《西安理工大学学报》2006年第2期195-198,共4页Journal of Xi'an University of Technology
基 金:陕西省自然科学专项基金项目(2003F13)
摘 要:提出了利用三次样条插值算法和最小均方误差(MMSE)算法代替线性插值算法和基于变换域的插值算法对OFDM系统的数据符号处的信道系数进行估计,并且在导频间隔不同时对4种算法进行了比较分析。仿真结果表明:改进后的算法可以大大节省系统的信噪比增益;在同时考虑计算复杂度和估计性能的条件下,导频宽度不同时,应采用不同的插值算法。当子信道具有频率选择性时,三次样条插值算法是最佳选择。This paper suggests that the cubic spline insertion value and minimum mean square error(MMSE) algorithms be used to replace the linear insertion value algorithm and the invertion value algorithm based on the transform field to estimate the number of signal channel coefficiet at data symbals in the OFDM system. Also, this paper makes a comparative analysis of 4 kinds of algorithms at the different intervals of pilot carriers. The simulation results indicate that the improved algorithms can greatly save the signal noise ratio benefits; and that in the case of considering calculation complexity and estimation performances, the insertion value algorithms of different kinds are adopted when the widths of pilot carriers are different, and that when the sub-signal channel has the frequency selection, the cubic spline insertion value algorithm is the best selection.
关 键 词:正交频分复用 导频 信道估计 三次样条插值 最小均方误差
分 类 号:TN91[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:52.15.60.240