检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:薛兆丰[1] 李智群[1] 王志功[1] 熊明珍[1] 李伟[1]
机构地区:[1]东南大学射频与光电集成电路研究所,南京210096
出 处:《Journal of Semiconductors》2006年第8期1373-1377,共5页半导体学报(英文版)
基 金:国家高技术研究发展计划资助项目(批准号:2002AA312240)~~
摘 要:This paper presents a low noise, 1.25Gb/s and 124dBΩ front-end amplifier that is designed and fabricated in 0.25μm CMOS technology for optical communication applications. Active inductor shunt peaking technology and noise optimization are used in the design of a trans-impedance amplifier,which overcomes the problem of inadequate bandwidth caused by the large parasitical capacitor of the CMOS photodiode. Experimental results indicate that with a parasitical capacitance of 2pF,this circuit works at 1.25Gb/s. A clear eye diagram is obtained with an input optical signal of - 17dBm. With a power supply of 3.3V, the front-end amplifier consumes 122mW and provides a 660mV differential output.设计并实现了一种基于TSMC 0·25μm CMOS工艺的低噪声、1·25Gb/s和124dBΩ的光接收机前端放大器.跨阻放大器设计采用了有源电感并联峰化和噪声优化技术,克服了CMOS光检测器大寄生电容造成的带宽不够的问题.测试结果表明,在2pF的寄生电容下,前端放大器工作速率达到了1·25Gb/s ,在光功率为-17dBm的光信号输入下得到了清晰的眼图.芯片采用3·3V电压供电,功耗为122mW,差分输出电压幅度为660mV.
关 键 词:front-end amplifier T1A shunt peaking active inductor
分 类 号:TN722.71[电子电信—电路与系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.249