检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李小刚[1] 蔡坚[1] YoonChulSohn QianWang WoonbaeKim
机构地区:[1]清华大学微电子所,北京 [2]三星先进技术研究院,韩国水原市
出 处:《电子工业专用设备》2007年第9期33-38,共6页Equipment for Electronic Products Manufacturing
摘 要:研究了用Ag-Sn作为键合中间层的圆片健合。相对于成熟的Au-Sn键合系统(典型键合温度是280℃),该系统可以提供更低成本、更高键合后分离(De-Bonding)温度的圆片级键合方案。使用直径为100mm硅片,盖板硅片上溅射多层金属Ti/Ni/Sn/Au,利用Lift-off工艺来形成图形。基板硅片上溅射Ti/Ni/Au/Ag。硅片制备好后,将盖板和基板叠放在一起送入键合机进行键合。键合过程在N2气氛中进行,键合过程中不需要使用助焊剂。研究了不同键合参数,如键合压力、温度等对键合结果的影响。剪切强度测试表明样品的剪切强度平均在55.17MPa。TMA测试表明键合后分离温度可以控制在500℃左右。He泄漏测试证明封接的气密性极好。A new bonding system, Ag-Sn, as the bonding media for wafer level packaging is investigated. Comparing to well developed Au-Sn bonding (typically bonding temperature of 280 ℃ ), Ag-Sn would provide a lower cost and higher de-bonding temperature wafer-level bonding method. Cap wafer was sputtered with thin films of Ti/Ni/Sn/Au and to form the pattern with the lift-off process. Ti/Ni/Ag was sputtered on substrate wafer. After the metallization the cap wafer and substrate wafer were brought into contact and sent into the bonder. Bonding process was performed in a nitrogen environment and no flux is used. Different bonding parameters such as bonding force and bonding temperature are studied. The average shear strength of 55.17MPa was achieved. TMA indicates the de-bonding temperature is about 500 ℃. Very good hermeticity was proved by He leakage test.
分 类 号:TN405[电子电信—微电子学与固体电子学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.63