2219-T4铝合金双轴肩FSW与常规FSW接头性能对比研究  

Comparison of joint properties of AA2219-T4 between conventional FSW and bobbin-tool FSW

作　　者：张健[1] 李光[1] 李从卿[1] 栾国红[1] 

机构地区：[1]北京航空制造工程研究所搅拌摩擦焊中心,100024

出　　处：《焊接》2008年第11期50-52,共3页Welding & Joining

基　　金：国家科技"十一五"支撑计划重点项目(2006BAF04B09)

摘　　要：对常规搅拌摩擦焊和双轴肩搅拌摩擦焊技术进行了比较,试验材料为6mm厚2219-T4铝合金。对两种焊缝的微观结构、显微硬度和力学性能进行了测试。结果表明双轴肩焊缝的宏观形貌与常规搅拌摩擦焊焊缝的不同,呈哑铃型。且由于双轴肩焊接的热输入量较高,其接头的显微硬度和力学性能普遍低于常规搅拌摩擦焊接头。双轴肩搅拌摩擦焊接头的抗拉强度可达到常规搅拌摩擦焊接头的90%。The comparison between the conventional FSW(friction stir welding) and bobbin-tool FSW technologies were presented.6mm thick 2219-T4 aluminum sheets were welded by the standard FSW and bobbin tool techniques,respectively.Microstructure,microhardness and me-chanical properties were tested.The results indicated that the bobbin-tool FSW welds look like a dumb-bell,which was different from the con-ventional FSW welds.The bobbin-tool FSW welds have lower microhardness and mechanical properties because of the higher heat input.Thetensile strength of bobbin-tool FSW welds can reach 90% of the conventional FSW welds.

关 键 词：搅拌摩擦焊 双轴肩 接头性能 铝合金 

分 类 号：TG453[金属学及工艺—焊接]