检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]江苏悦达纺织集团有限公司,江苏盐城224005
出 处:《纺织器材》2009年第3期31-34,共4页Textile Accessories
摘 要:采用德国绪森公司的倚丽集聚纺器材、专件和板簧加压摇架纺CF 11.7 tex纱,通过生产实践指出,摇架三档压力宜偏重掌握,胶辊采用邵尔A65度低硬高弹品种,导纱动程以3.5 mm^4.5 mm为宜,异型吸管负压宜控制在(2.6±0.3)kPa,用进口与国产网圈均可,卷捻宜用布雷克钢领、钢丝圈。认为集聚纺纱线的配棉应从严控制,温湿度要加强管理,基础管理工作要加强,机械设备状况要保证,专件管理和工艺配置要跟上,运转操作和机台清洁管理要规范。Application of Suessen compact spinning parts and weighted top cradle shows that the third pressure 0f top cradle should be more than designed with the cots of Shore A 65 low hardness and high elasticity,working width 3.5-4.5mm. The back pressure of the profiled suction tube should be (2.6±0.3) kPa. Both domestic and overseas aprons work. Bracker rings and travellers are recommended. Conclusuion is made that cotton preparation is important for compact spinning. It is same with humiture. The general work should be reinforced. Mechanical equipment performance should be guarantted followed with proper parts and process configuration. Operation and cleaning work should be in conformity with criterion.
关 键 词:集聚纺 专件器材 工艺配置 外围条件 动态检查 运转操作 基础管理
分 类 号:TS103.114[轻工技术与工程—纺织工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.170